Lines Matching +full:master +full:- +full:side

1 /* SPDX-License-Identifier: GPL-2.0-only */
3  * arch/arm/mach-at91/pm_slow_clock.S
13 #include "pm_data-offsets.h"
24  * Wait until master clock is ready (after switching master clock source)
26  * @r_mckid:	register holding master clock identifier
28  * Side effects: overwrites r7, r8
45  * Wait until master oscillator has stabilized.
47  * Side effects: overwrites r7
58  * Side effects: overwrites r7
69  * Side effects: overwrites r7
88  * @ena: 0 - disable regulator
89  *	 1 - enable regulator
91  * Side effects: overwrites r7, r8, r9, r10
121  * Enable self-refresh
123  * Side effects: overwrites r2, r3, tmp1, tmp2, tmp3, r7
160 	/* Switch to self-refresh. */
166 	/* Wait for self-refresh enter. */
172 	/* Put DDR PHY's DLL in bypass mode for non-backup modes. */
199  * Disable self-refresh
201  * Side effects: overwrites r2, r3, tmp1, tmp2, tmp3
229 	/* Enable quasi-dynamic programming. */
233 	/* De-assert SDRAM initialization. */
238 	/* Quasi-dynamic programming done. */
247 	/* DLL soft-reset + DLL lock wait + ITM reset */
258 	/* Enable quasi-dynamic programming. */
277 	/* Trigger self-refresh exit. */
283 	/* Wait for self-refresh exit done. */
314  * Enable self-refresh
328 	/* Active SDRAM self-refresh mode */
341 	/* LPDDR1 --> force DDR2 mode during self-refresh */
351 	/* Active DDRC self-refresh mode */
372 	/* Active DDRC self-refresh mode */
386 	/* Active SDRAMC self-refresh mode */
400  * Disable self-refresh
419 	  * For exiting the self-refresh mode, do nothing,
420 	  * automatically exit the self-refresh mode.
571 	/* Switch the main clock source to 12-MHz RC oscillator */
587 	/* Switch the master clock source to main clock */
617 	/* Switch the master clock source to slow clock */
633 	/* Switch the master clock source to main clock */
800  * Side effects: overwrites tmp1, tmp2
856  * Side effects: overwrites tmp1, tmp2
917 	/* Save Master clock setting */
922 	 * Set master clock source to:
923 	 * - MAINCK if using ULP0 fast variant
924 	 * - slow clock, otherwise
961 	 * Restore master clock setting
974 	/* Switch the master clock source to slow clock. */
1007 /* at91_pm_suspend_in_sram must be 8-byte aligned per the requirements of fncpy() */
1011 	stmfd	sp!, {r4 - r12, lr}
1032 	 * to RAM may be limited while in self-refresh.
1067 	/* Active the self-refresh mode */
1089 	/* Exit the self-refresh mode */
1093 	ldmfd	sp!, {r4 - r12, pc}
1142 	.word .-at91_pm_suspend_in_sram