Lines Matching +full:num +full:- +full:interpolated +full:- +full:steps
1 // SPDX-License-Identifier: GPL-2.0-or-later OR MIT
7 #include <dt-bindings/display/sdtv-standards.h>
8 #include <dt-bindings/gpio/gpio.h>
9 #include <dt-bindings/input/input.h>
10 #include <dt-bindings/leds/common.h>
11 #include <dt-bindings/media/tvp5150.h>
12 #include <dt-bindings/sound/fsl-imx-audmux.h>
16 stdout-path = &uart4;
20 compatible = "pwm-backlight";
21 pinctrl-names = "default";
22 pinctrl-0 = <&pinctrl_backlight>;
24 brightness-levels = <0 16 64 255>;
25 num-interpolated-steps = <16>;
26 default-brightness-level = <1>;
27 power-supply = <®_3v3>;
28 enable-gpios = <&gpio4 28 GPIO_ACTIVE_HIGH>;
32 compatible = "composite-video-connector";
34 sdtv-standards = <SDTV_STD_PAL_B>;
38 remote-endpoint = <&tvp5150_comp0_in>;
43 counter-0 {
44 compatible = "interrupt-counter";
45 pinctrl-names = "default";
46 pinctrl-0 = <&pinctrl_counter0>;
50 counter-1 {
51 compatible = "interrupt-counter";
52 pinctrl-names = "default";
53 pinctrl-0 = <&pinctrl_counter1>;
57 counter-2 {
58 compatible = "interrupt-counter";
59 pinctrl-names = "default";
60 pinctrl-0 = <&pinctrl_counter2>;
64 gpio-keys {
65 compatible = "gpio-keys";
72 wakeup-source;
77 compatible = "gpio-leds";
78 pinctrl-names = "default";
79 pinctrl-0 = <&pinctrl_leds>;
81 led-0 {
85 linux,default-trigger = "heartbeat";
88 led-1 {
92 linux,default-trigger = "disk-activity";
95 led-2 {
99 default-state = "on";
106 power-supply = <®_3v3>;
110 remote-endpoint = <&lvds0_out>;
115 reg_1v8: regulator-1v8 {
116 compatible = "regulator-fixed";
117 regulator-name = "1v8";
118 regulator-min-microvolt = <1800000>;
119 regulator-max-microvolt = <1800000>;
122 reg_3v3: regulator-3v3 {
123 compatible = "regulator-fixed";
124 regulator-name = "3v3";
125 regulator-min-microvolt = <3300000>;
126 regulator-max-microvolt = <3300000>;
129 reg_h1_vbus: regulator-h1-vbus {
130 compatible = "regulator-fixed";
131 regulator-name = "h1-vbus";
132 regulator-min-microvolt = <5000000>;
133 regulator-max-microvolt = <5000000>;
135 enable-active-high;
138 reg_otg_vbus: regulator-otg-vbus {
139 compatible = "regulator-fixed";
140 regulator-name = "otg-vbus";
141 regulator-min-microvolt = <5000000>;
142 regulator-max-microvolt = <5000000>;
144 enable-active-high;
147 reg_wifi: regulator-wifi {
148 compatible = "regulator-fixed";
149 pinctrl-names = "default";
150 pinctrl-0 = <&pinctrl_wifi_npd>;
151 regulator-name = "wifi";
152 regulator-min-microvolt = <1800000>;
153 regulator-max-microvolt = <1800000>;
155 enable-active-high;
156 startup-delay-us = <70000>;
160 compatible = "simple-audio-card";
161 simple-audio-card,name = "prti6q-sgtl5000";
162 simple-audio-card,format = "i2s";
163 simple-audio-card,widgets =
168 simple-audio-card,routing =
174 simple-audio-card,cpu {
175 sound-dai = <&ssi1>;
176 system-clock-frequency = <0>; /* Do NOT call fsl_ssi_set_dai_sysclk! */
179 simple-audio-card,codec {
180 sound-dai = <&codec>;
181 bitclock-master;
182 frame-master;
188 pinctrl-names = "default";
189 pinctrl-0 = <&pinctrl_audmux>;
192 mux-ssi1 {
193 fsl,audmux-port = <0>;
194 fsl,port-config = <
203 mux-pins3 {
204 fsl,audmux-port = <2>;
205 fsl,port-config = <
213 pinctrl-names = "default";
214 pinctrl-0 = <&pinctrl_can1>;
219 pinctrl-names = "default";
220 pinctrl-0 = <&pinctrl_can2>;
225 assigned-clocks = <&clks IMX6QDL_CLK_LDB_DI0_SEL>;
226 assigned-clock-parents = <&clks IMX6QDL_CLK_PLL5_VIDEO_DIV>;
230 cs-gpios = <&gpio3 19 GPIO_ACTIVE_LOW>;
231 pinctrl-names = "default";
232 pinctrl-0 = <&pinctrl_ecspi1>;
236 compatible = "jedec,spi-nor";
238 spi-max-frequency = <20000000>;
243 pinctrl-names = "default";
244 pinctrl-0 = <&pinctrl_enet>;
245 phy-mode = "rgmii-id";
246 phy-handle = <&rgmii_phy>;
250 #address-cells = <1>;
251 #size-cells = <0>;
254 rgmii_phy: ethernet-phy@0 {
256 interrupts-extended = <&gpio1 28 IRQ_TYPE_LEVEL_LOW>;
257 reset-gpios = <&gpio1 25 GPIO_ACTIVE_LOW>;
258 reset-assert-us = <10000>;
259 reset-deassert-us = <300>;
265 gpio-line-names =
277 gpio-line-names =
286 gpio-line-names =
295 gpio-line-names =
304 gpio-line-names =
314 gpio-line-names =
325 gpio-line-names =
334 clock-frequency = <100000>;
335 pinctrl-names = "default";
336 pinctrl-0 = <&pinctrl_i2c1>;
339 codec: audio-codec@a {
342 #sound-dai-cells = <0>;
344 VDDA-supply = <®_3v3>;
345 VDDIO-supply = <®_3v3>;
346 VDDD-supply = <®_1v8>;
349 video-decoder@5c {
352 #address-cells = <1>;
353 #size-cells = <0>;
359 remote-endpoint = <&comp0_out>;
368 remote-endpoint = <&ipu1_csi0_mux_from_parallel_sensor>;
375 clock-frequency = <100000>;
376 pinctrl-names = "default";
377 pinctrl-0 = <&pinctrl_i2c3>;
383 #address-cells = <1>;
384 #size-cells = <0>;
416 temperature-sensor@70 {
423 pinctrl-names = "default";
424 pinctrl-0 = <&pinctrl_ipu1_csi0>;
429 remote-endpoint = <&tvp5151_to_ipu1_csi0_mux>;
435 lvds-channel@0 {
442 remote-endpoint = <&panel_in>;
453 pinctrl-names = "default";
454 pinctrl-0 = <&pinctrl_pwm1>;
459 #sound-dai-cells = <0>;
460 fsl,mode = "ac97-slave";
465 pinctrl-names = "default";
466 pinctrl-0 = <&pinctrl_uart1>;
471 pinctrl-names = "default";
472 pinctrl-0 = <&pinctrl_uart2>;
477 pinctrl-names = "default";
478 pinctrl-0 = <&pinctrl_uart3>;
483 pinctrl-names = "default";
484 pinctrl-0 = <&pinctrl_uart4>;
489 pinctrl-names = "default";
490 pinctrl-0 = <&pinctrl_uart5>;
495 vbus-supply = <®_h1_vbus>;
496 pinctrl-names = "default";
503 vbus-supply = <®_otg_vbus>;
504 pinctrl-names = "default";
505 pinctrl-0 = <&pinctrl_usbotg>;
508 disable-over-current;
513 pinctrl-names = "default";
514 pinctrl-0 = <&pinctrl_usdhc1>;
515 cd-gpios = <&gpio1 1 GPIO_ACTIVE_LOW>;
516 no-1-8-v;
517 disable-wp;
518 cap-sd-highspeed;
519 no-mmc;
520 no-sdio;
525 pinctrl-names = "default";
526 pinctrl-0 = <&pinctrl_usdhc2>;
527 vmmc-supply = <®_wifi>;
528 non-removable;
529 cap-power-off-card;
530 keep-power-in-suspend;
531 no-1-8-v;
532 no-mmc;
533 no-sd;
538 interrupts-extended = <&gpio1 30 IRQ_TYPE_LEVEL_HIGH>;
539 ref-clock-frequency = "38400000";
540 tcxo-clock-frequency = "19200000";
545 pinctrl-names = "default";
546 pinctrl-0 = <&pinctrl_usdhc3>;
547 bus-width = <8>;
548 no-1-8-v;
549 non-removable;
550 no-sd;
551 no-sdio;
556 pinctrl-names = "default";
557 pinctrl-0 = <&pinctrl_hog>;