Lines Matching +full:retain +full:- +full:state +full:- +full:suspended
1 // SPDX-License-Identifier: GPL-2.0 OR X11
5 #include <dt-bindings/gpio/gpio.h>
6 #include <dt-bindings/input/input.h>
10 stdout-path = &uart2;
19 compatible = "simple-bus";
20 #address-cells = <1>;
21 #size-cells = <0>;
24 compatible = "regulator-fixed";
26 regulator-name = "2P5V";
27 regulator-min-microvolt = <2500000>;
28 regulator-max-microvolt = <2500000>;
29 regulator-always-on;
33 compatible = "regulator-fixed";
35 regulator-name = "3P3V";
36 regulator-min-microvolt = <3300000>;
37 regulator-max-microvolt = <3300000>;
38 regulator-always-on;
42 compatible = "regulator-fixed";
44 regulator-name = "usb_otg_vbus";
45 regulator-min-microvolt = <5000000>;
46 regulator-max-microvolt = <5000000>;
48 enable-active-high;
52 compatible = "regulator-fixed";
54 pinctrl-names = "default";
55 pinctrl-0 = <&pinctrl_wlan_vmmc>;
56 regulator-name = "reg_wlan_vmmc";
57 regulator-min-microvolt = <1800000>;
58 regulator-max-microvolt = <1800000>;
60 startup-delay-us = <70000>;
61 enable-active-high;
65 gpio-keys {
66 compatible = "gpio-keys";
67 pinctrl-names = "default";
68 pinctrl-0 = <&pinctrl_gpio_keys>;
84 compatible = "gpio-leds";
85 pinctrl-names = "default";
86 pinctrl-0 = <&pinctrl_leds>;
88 j14-pin1 {
90 retain-state-suspended;
91 default-state = "off";
94 j14-pin3 {
96 retain-state-suspended;
97 default-state = "off";
100 j14-pins8-9 {
102 retain-state-suspended;
103 default-state = "off";
106 j46-pin2 {
108 retain-state-suspended;
109 default-state = "off";
112 j46-pin3 {
114 retain-state-suspended;
115 default-state = "off";
119 backlight-lcd {
120 compatible = "pwm-backlight";
122 brightness-levels = <0 4 8 16 32 64 128 255>;
123 default-brightness-level = <7>;
124 power-supply = <®_3p3v>;
128 backlight_lvds0: backlight-lvds0 {
129 compatible = "pwm-backlight";
131 brightness-levels = <0 4 8 16 32 64 128 255>;
132 default-brightness-level = <7>;
133 power-supply = <®_3p3v>;
137 panel-lvds0 {
143 remote-endpoint = <&lvds0_out>;
149 compatible = "fsl,imx6dl-nit6xlite-sgtl5000",
150 "fsl,imx-audio-sgtl5000";
151 model = "imx6dl-nit6xlite-sgtl5000";
152 ssi-controller = <&ssi1>;
153 audio-codec = <&codec>;
154 audio-routing =
158 mux-int-port = <1>;
159 mux-ext-port = <3>;
164 pinctrl-names = "default";
165 pinctrl-0 = <&pinctrl_audmux>;
170 assigned-clocks = <&clks IMX6QDL_CLK_LDB_DI0_SEL>,
172 assigned-clock-parents = <&clks IMX6QDL_CLK_PLL3_USB_OTG>,
177 cs-gpios = <&gpio3 19 GPIO_ACTIVE_LOW>;
178 pinctrl-names = "default";
179 pinctrl-0 = <&pinctrl_ecspi1>;
184 spi-max-frequency = <20000000>;
190 pinctrl-names = "default";
191 pinctrl-0 = <&pinctrl_enet>;
192 phy-mode = "rgmii";
193 phy-handle = <ðphy>;
194 phy-reset-gpios = <&gpio1 27 GPIO_ACTIVE_LOW>;
195 interrupts-extended = <&gpio1 6 IRQ_TYPE_LEVEL_HIGH>,
197 fsl,err006687-workaround-present;
201 #address-cells = <1>;
202 #size-cells = <0>;
204 ethphy: ethernet-phy {
205 compatible = "ethernet-phy-ieee802.3-c22";
206 txen-skew-ps = <0>;
207 txc-skew-ps = <3000>;
208 rxdv-skew-ps = <0>;
209 rxc-skew-ps = <3000>;
210 rxd0-skew-ps = <0>;
211 rxd1-skew-ps = <0>;
212 rxd2-skew-ps = <0>;
213 rxd3-skew-ps = <0>;
214 txd0-skew-ps = <0>;
215 txd1-skew-ps = <0>;
216 txd2-skew-ps = <0>;
217 txd3-skew-ps = <0>;
223 ddc-i2c-bus = <&i2c2>;
228 clock-frequency = <100000>;
229 pinctrl-names = "default";
230 pinctrl-0 = <&pinctrl_i2c1>;
235 pinctrl-names = "default";
236 pinctrl-0 = <&pinctrl_sgtl5000>;
239 VDDA-supply = <®_2p5v>;
240 VDDIO-supply = <®_3p3v>;
245 clock-frequency = <100000>;
246 pinctrl-names = "default";
247 pinctrl-0 = <&pinctrl_i2c2>;
252 clock-frequency = <100000>;
253 pinctrl-names = "default";
254 pinctrl-0 = <&pinctrl_i2c3>;
260 interrupt-parent = <&gpio1>;
262 wakeup-gpios = <&gpio1 9 GPIO_ACTIVE_LOW>;
266 compatible = "edt,edt-ft5x06";
268 interrupt-parent = <&gpio1>;
270 wakeup-source;
275 pinctrl-names = "default";
276 pinctrl-0 = <&pinctrl_rtc>;
278 interrupts-extended = <&gpio2 26 IRQ_TYPE_LEVEL_LOW>;
283 pinctrl-names = "default";
284 pinctrl-0 = <&pinctrl_j10>;
285 pinctrl-1 = <&pinctrl_j28>;
287 imx6dl-nit6xlite {
330 pinctrl_gpio_keys: gpio-keysgrp {
413 pinctrl_wlan_vmmc: wlan-vmmcgrp {
492 lvds-channel@0 {
499 remote-endpoint = <&panel_in_lvds0>;
510 #pwm-cells = <2>;
511 pinctrl-names = "default";
512 pinctrl-0 = <&pinctrl_pwm1>;
517 pinctrl-names = "default";
518 pinctrl-0 = <&pinctrl_pwm3>;
523 #pwm-cells = <2>;
524 pinctrl-names = "default";
525 pinctrl-0 = <&pinctrl_pwm4>;
534 pinctrl-names = "default";
535 pinctrl-0 = <&pinctrl_uart1>;
540 pinctrl-names = "default";
541 pinctrl-0 = <&pinctrl_uart2>;
546 pinctrl-names = "default";
547 pinctrl-0 = <&pinctrl_uart3>;
548 uart-has-rtscts;
557 vbus-supply = <®_usb_otg_vbus>;
558 pinctrl-names = "default";
559 pinctrl-0 = <&pinctrl_usbotg>;
560 disable-over-current;
565 pinctrl-names = "default";
566 pinctrl-0 = <&pinctrl_usdhc2>;
567 bus-width = <4>;
568 non-removable;
569 vmmc-supply = <®_3p3v>;
570 vqmmc-supply = <®_wlan_vmmc>;
571 cap-power-off-card;
572 keep-power-in-suspend;
577 pinctrl-names = "default";
578 pinctrl-0 = <&pinctrl_usdhc3>;
579 cd-gpios = <&gpio7 0 GPIO_ACTIVE_LOW>;
580 vmmc-supply = <®_3p3v>;