Lines Matching +full:gpio +full:- +full:always +full:- +full:on
1 // SPDX-License-Identifier: GPL-2.0-or-later
6 /dts-v1/;
8 #include <dt-bindings/gpio/gpio.h>
12 model = "Data Modul eDM-QMX6 Board";
13 compatible = "dmo,imx6q-edmqmx6", "fsl,imx6q";
16 stdout-path = &uart2;
22 stmpe-i2c0 = &stmpe1;
23 stmpe-i2c1 = &stmpe2;
32 compatible = "simple-bus";
33 #address-cells = <1>;
34 #size-cells = <0>;
37 compatible = "regulator-fixed";
39 regulator-name = "3P3V";
40 regulator-min-microvolt = <3300000>;
41 regulator-max-microvolt = <3300000>;
42 regulator-always-on;
46 compatible = "regulator-fixed";
48 regulator-name = "usb_otg_switch";
49 regulator-min-microvolt = <5000000>;
50 regulator-max-microvolt = <5000000>;
51 gpio = <&gpio7 12 0>;
52 regulator-boot-on;
53 regulator-always-on;
57 compatible = "regulator-fixed";
59 regulator-name = "usb_host1_en";
60 regulator-min-microvolt = <3300000>;
61 regulator-max-microvolt = <3300000>;
62 gpio = <&gpio3 31 0>;
63 enable-active-high;
67 gpio-leds {
68 compatible = "gpio-leds";
70 led-blue {
73 linux,default-trigger = "heartbeat";
76 led-green {
81 led-pink {
86 led-red {
94 pinctrl-names = "default";
95 pinctrl-0 = <&pinctrl_can1>;
100 pinctrl-names = "default";
101 pinctrl-0 = <&pinctrl_ecspi5>;
102 cs-gpios = <&gpio1 12 GPIO_ACTIVE_LOW>;
106 compatible = "m25p80", "jedec,spi-nor";
107 spi-max-frequency = <40000000>;
113 pinctrl-names = "default";
114 pinctrl-0 = <&pinctrl_enet>;
115 phy-mode = "rgmii-id";
116 phy-reset-gpios = <&gpio1 25 GPIO_ACTIVE_LOW>;
117 phy-supply = <&vgen2_1v2_eth>;
122 clock-frequency = <100000>;
123 pinctrl-names = "default";
124 pinctrl-0 = <&pinctrl_i2c1>;
129 clock-frequency = <100000>;
130 pinctrl-names = "default";
131 pinctrl-0 = <&pinctrl_i2c2
140 interrupt-parent = <&gpio3>;
145 regulator-min-microvolt = <300000>;
146 regulator-max-microvolt = <1875000>;
147 regulator-boot-on;
148 regulator-always-on;
152 regulator-min-microvolt = <300000>;
153 regulator-max-microvolt = <1875000>;
154 regulator-boot-on;
155 regulator-always-on;
159 regulator-min-microvolt = <800000>;
160 regulator-max-microvolt = <3300000>;
161 regulator-boot-on;
162 regulator-always-on;
166 regulator-min-microvolt = <400000>;
167 regulator-max-microvolt = <1975000>;
168 regulator-boot-on;
169 regulator-always-on;
173 regulator-min-microvolt = <400000>;
174 regulator-max-microvolt = <1975000>;
175 regulator-boot-on;
176 regulator-always-on;
180 regulator-min-microvolt = <400000>;
181 regulator-max-microvolt = <1975000>;
182 regulator-always-on;
186 regulator-min-microvolt = <5000000>;
187 regulator-max-microvolt = <5150000>;
188 regulator-always-on;
192 regulator-min-microvolt = <1000000>;
193 regulator-max-microvolt = <3000000>;
194 regulator-boot-on;
195 regulator-always-on;
199 regulator-boot-on;
200 regulator-always-on;
204 regulator-min-microvolt = <800000>;
205 regulator-max-microvolt = <1550000>;
209 regulator-min-microvolt = <800000>;
210 regulator-max-microvolt = <1550000>;
214 regulator-min-microvolt = <1800000>;
215 regulator-max-microvolt = <3300000>;
216 regulator-boot-on;
217 regulator-always-on;
221 regulator-min-microvolt = <1800000>;
222 regulator-max-microvolt = <3300000>;
223 regulator-always-on;
227 regulator-min-microvolt = <1800000>;
228 regulator-max-microvolt = <3300000>;
229 regulator-always-on;
233 regulator-min-microvolt = <1800000>;
234 regulator-max-microvolt = <3300000>;
235 regulator-always-on;
244 interrupt-parent = <&gpio3>;
245 vcc-supply = <&sw2_reg>;
246 vio-supply = <&sw2_reg>;
249 #gpio-cells = <2>;
250 compatible = "st,stmpe-gpio";
258 interrupt-parent = <&gpio5>;
259 vcc-supply = <&sw2_reg>;
260 vio-supply = <&sw2_reg>;
263 #gpio-cells = <2>;
264 compatible = "st,stmpe-gpio";
285 clock-frequency = <100000>;
286 pinctrl-names = "default";
287 pinctrl-0 = <&pinctrl_i2c3>;
292 pinctrl-names = "default";
293 pinctrl-0 = <&pinctrl_hog>;
295 imx6q-dmo-edmqmx6 {
310 pinctrl_ecspi5: ecspi5rp-1 {
431 pinctrl-names = "default";
432 pinctrl-0 = <&pinctrl_pcie>;
433 reset-gpio = <&gpio4 8 GPIO_ACTIVE_LOW>;
442 pinctrl-names = "default";
443 pinctrl-0 = <&pinctrl_uart1>;
448 pinctrl-names = "default";
449 pinctrl-0 = <&pinctrl_uart2>;
454 vbus-supply = <®_usb_host1>;
455 disable-over-current;
461 pinctrl-names = "default";
462 pinctrl-0 = <&pinctrl_usbotg>;
463 disable-over-current;
468 pinctrl-names = "default";
469 pinctrl-0 = <&pinctrl_usdhc3>;
470 vmmc-supply = <®_3p3v>;
475 pinctrl-names = "default";
476 pinctrl-0 = <&pinctrl_usdhc4>;
477 vmmc-supply = <®_3p3v>;
478 non-removable;
479 bus-width = <8>;