Lines Matching full:default
11 - 0 - disabled (default)
17 parameters to their default state (RFC1122 for hosts, RFC1812
21 Default value of TTL field (Time To Live) for outgoing (but not
23 Default: 64 (as recommended by RFC1700)
49 Default: FALSE
52 default 552 - minimum discovered Path MTU
55 By default we don't trust protocol path MTUs while forwarding
63 Default: 0 (disabled)
76 Default: 0
84 Default: 0 (disabled)
95 Default: 0 (Layer 3)
130 Default: 0x0007 (source IP, destination IP and IP protocol)
136 Default: 512kB Minimum: 64kB Maximum: 64MB
143 Default: 1 (Update priority.)
157 neigh/default/gc_thresh1 - INTEGER
161 Default: 128
163 neigh/default/gc_thresh2 - INTEGER
168 Default: 512
170 neigh/default/gc_thresh3 - INTEGER
175 Default: 1024
177 neigh/default/unres_qlen_bytes - INTEGER
184 Default: SK_WMEM_MAX, (same as net.core.wmem_default).
190 neigh/default/unres_qlen - INTEGER
196 Prior to linux 3.3, the default value is 3 which may cause
197 unexpected packet loss. The current default value is calculated
198 according to default value of unres_qlen_bytes and true size of
201 Default: 101
223 Default: 0 (Do not emit notifications.)
266 Default: 64
299 reset them. Default state is FALSE. It means that if overflow
312 Default: 1
319 Default is "reno" and the default setting (tcp_congestion_control).
325 Default: 31
336 Default : 1
352 Default : 48
361 Default : 48 (at least 8 bytes of payload per segment)
367 Default is set as part of kernel configuration.
386 Default: 3
405 Default: 2
415 Default: 1 (fallback enabled)
430 Default: 60 seconds
439 By default it's enabled with a non-zero value. 0 disables F-RTO.
450 Default: 0
472 Default: 500 (milliseconds).
476 Default: 2hours.
480 connection is broken. Default value: 9.
485 after probes started. Default value: 75sec i.e. connection
496 Default: 0 (disabled)
508 if network conditions require more than default value,
533 if network conditions require more than default value.
558 Default: 300
564 default.
571 - 1 - Disabled by default, enabled when an ICMP black hole detected
576 Discovery reprobe. The default is reprobing every 10 minutes as
581 will stop in respect to the width of search range in bytes. Default
585 By default, TCP saves various connection metrics in the route cache
595 Default is 1, which disables ssthresh metrics.
602 The default value is 8.
622 Default: 0x1
629 Default: 3
636 Default: 300
650 default.
659 The default value of 15 yields a hypothetical timeout of 924.6
672 Default: 0
674 tcp_rmem - vector of 3 INTEGERs: min, default, max
679 Default: 4K
681 default: initial size of receive buffer used by TCP sockets.
683 Default: 131072 bytes.
691 Default: between 131072 and 6MB, depending on RAM size.
699 The default is 1ms, based on TSO autosizing period.
701 Default : 1,000,000 ns (1 ms)
709 Default : 100,000 ns (100 us)
715 Default : 44
723 Default: 1
730 Default: FALSE
734 be retransmitted. Should not be higher than 255. Default value
743 Default: 1
787 Default: 0
793 The client support is enabled by flag 0x1 (on by default). The client
797 The server support is enabled by flag 0x2 (off by default). Then
813 default without explicit TCP_FASTOPEN socket option.
816 Default: 0x1
829 By default, it is set to 0 (feature is disabled).
853 will be retransmitted. Should not be higher than 127. Default value
866 Default: 1
877 Default: 2
886 Default: 200
894 Default: 120
902 Default: 3
915 Default: 2
920 tcp_wmem - vector of 3 INTEGERs: min, default, max
924 Default: 4K
926 default: initial size of send buffer used by TCP sockets. This
931 Default: 16K
939 Default: between 64K and 4MB, depending on RAM size.
952 Default: UINT_MAX (0xFFFFFFFF)
960 Default: 0
973 Default: 0
985 Default: 1048576 (16 * 65536)
990 Default: 1000
998 Default: 0 (disabled)
1010 Default: 0 (disabled)
1023 Default is calculated at boot time from amount of available memory.
1030 Default: 4K
1037 Default: 4K
1049 Default: 1 (enabled)
1061 Default: 1
1071 Default: 10
1079 Default: 0
1089 Default: 0
1101 The default values are 32768 and 60999 respectively.
1134 Default: Empty
1143 Default: 1024
1149 Default: 0
1152 By default, bind() does not select the ports automatically even if
1158 Default: 0
1166 Default: 0
1176 Default: 1
1180 The default is "1 0", meaning, that nobody (not even root) may
1188 Default: 1
1194 Default: 1
1200 Default: 0
1206 Default: 0
1212 Default: 1
1222 Default: 1000
1230 Default: 1000
1237 Default: 50
1244 Default mask: 0000001100000011000 (6168)
1264 .. [1] These are rate limited by default (see default mask above)
1272 Default: 1
1289 Default: 0
1293 Default: 20
1317 Default: 10
1322 Default: 2 (as specified by RFC2236 8.1)
1327 - 0 - (default) No enforcement of a IGMP version, IGMPv1/v2 fallback
1334 - 3 - Enforce to use IGMP version 3. The same react with default 0.
1341 this value as default 0 is recommended.
1370 default:
1389 The default value 0 means that the device is the only interface
1432 default TRUE
1445 default TRUE
1454 Default: TRUE
1463 default FALSE
1472 default
1481 default FALSE
1487 default FALSE
1494 By default failed packets are discarded.
1507 Default value is 0. Note that some distributions enable it
1527 Default value is 0.
1537 - 0 - (default) The kernel can respond to arp requests with addresses
1553 - 0 - (default) Use any local address, configured on any interface
1584 - 0 - (default): reply for any local target IP address, configured
1603 0 (default): do nothing
1650 Default: 10000 (10 seconds)
1656 Default: 1000 (1 seconds)
1671 1122, but is disabled by default for compatibility reasons.
1673 Default: off (0)
1680 Default: off (0)
1686 Default value is 0.
1698 Default TRUE
1720 Default value for IPV6_V6ONLY socket option,
1727 Default: FALSE (as specified in RFC3493)
1737 Default: TRUE
1747 1 automatic flow labels are enabled by default, they can be
1756 Default: 1
1766 Default: true
1788 Default: 0
1793 Default: 0 (Layer 3)
1828 Default: 0x0007 (source IP, destination IP and IP protocol)
1837 Default: FALSE
1844 Default: 1 (as specified in RFC7217)
1850 Default: 3 (as specified in RFC7217)
1855 Default: 2 (as specified by RFC3810 9.1)
1865 Default: 8
1873 Default: 8
1879 Default: INT_MAX (unlimited)
1885 Default: INT_MAX (unlimited)
1890 generate this message; IPv6 does by default. Setting this sysctl
1894 Default: false (generate message)
1899 default which means route dumps and notifications contain the new
1906 Default: true (backward compat mode)
1921 Default: 0 (Do not emit notifications.)
1935 Default: 0xFFFFFF
1944 Default: 0xFFFFFFFFFFFFFF
1960 ``conf/default/*``:
1961 Change the interface-specific default settings.
1972 Changing this value is same as changing ``conf/default/disable_ipv6``
2001 Default: 0
2026 Functional default:
2032 Learn default router in Router Advertisement.
2034 Functional default:
2040 Route metric for default route learned in Router Advertisement. This value
2041 will be assigned as metric for the default route learned via IPv6 Router
2047 Default: IP6_RT_PRIO_USER i.e. 1024.
2053 Default is to NOT accept these as it may be an un-intended
2056 Functional default:
2069 Default: 1
2074 Functional default:
2085 Functional default:
2096 Functional default:
2104 Functional default:
2113 Functional default:
2121 Functional default:
2132 Default: 0
2138 Functional default:
2146 Default: 1
2163 By default, Host behaviour is assumed. This means:
2166 2. If accept_ra is TRUE (default), transmit Router
2168 3. If accept_ra is TRUE (default), accept Router
2170 4. If accept_redirects is TRUE (default), accept Redirects.
2182 Default: 0 (disabled) if global forwarding is disabled (default),
2186 Default Hop Limit to set.
2188 Default: 64
2191 Default Maximum Transfer Unit
2193 Default: 1280 (IPv6 required minimum)
2199 Default: 0
2205 Default: 60
2211 Default: 1
2216 Default: 4
2222 Default: 3
2229 Default: false
2240 Default:
2248 Default: 172800 (2 days)
2253 Default: 86400 (1 day)
2260 * 0 : system default
2263 Default: 0 (addresses are removed)
2271 Default: 600
2277 Default: 5
2285 Default: 16
2292 Default: FALSE (enable IPv6 operation)
2308 1 Enable DAD (default)
2320 Default: FALSE
2338 * 0 - (default): do nothing
2343 The IPv6 Traffic Class to use by default when sending IPv6 Neighbor
2350 * 0 - (default)
2356 Default: 10000 (10 seconds)
2362 Default: 1000 (1 second)
2365 * 0 - (default) No enforcement of a MLD version, MLDv1 fallback allowed
2373 * 1 - (default) discard fragmented neighbor discovery packets
2379 * 0: disabled (default)
2392 * 0: disabled (default)
2402 be stable privacy ones by default. This can be changed via the
2403 addrgenmode ip-link. conf/default/stable_secret is used as the
2410 By default the stable secret is unset.
2416 0 generate address based on EUI64 (default)
2428 By default this is turned off.
2435 By default this is turned off.
2445 Default: TRUE
2456 Default: 1000
2471 Default: 0-1,3-127 (rate limit ICMPv6 errors except Packet Too Big)
2477 Default: 0
2483 Default: 0
2489 Default: 0
2510 Default: 1
2516 Default: 1
2522 Default: 1
2528 Default: 0
2534 Default: 0
2546 Default: 0
2561 Default: 0
2580 Default: 1
2602 Default: 0
2622 Default: 0
2633 Default: 0
2642 Default: 1
2648 Default: 4
2655 Default: 10
2662 Default: 8
2670 Default: 5
2686 Default: 0
2695 is disabled by initializing 'ps_retrans' per netns as 0xffff by default,
2698 Default: 0xffff
2705 Default: 3000
2711 Default: 60000
2717 Default: 1000
2724 Default: 30000
2730 Default: 200
2733 The default lifetime of the SCTP cookie (in milliseconds). The cookie
2736 Default: 60000
2745 Default: 1
2760 Default: Dependent on configuration. MD5 if available, else SHA1 if
2777 Default: 0
2785 Default: 0
2798 Default is calculated at boot time from amount of available memory.
2800 sctp_rmem - vector of 3 INTEGERs: min, default, max
2801 Only the first value ("min") is used, "default" and "max" are
2808 Default: 4K
2810 sctp_wmem - vector of 3 INTEGERs: min, default, max
2821 Default: 1
2836 Default: 0
2839 The default remote UDP encapsulation port.
2842 outgoing UDP-encapsulated SCTP packets by default. Users can also
2852 Default: 0
2864 Default: 0
2879 Default: 10