Lines Matching full:note
28 This driver supports XDP (Express Data Path) and AF_XDP zero-copy. Note that
115 NOTE: The rx_bytes value of ethtool does not match the rx_bytes value of
131 NOTE: This setting is not saved across reboots.
147 NOTE: Your distribution should likely have provided the latest DDP file, but if
204 NOTE: The presence of a device-specific DDP package file overrides the loading
216 NOTE: This driver supports the following flow types:
232 NOTE: This driver allows you to filter traffic based on a user-defined flexible
247 NOTE: When you disable ntuple filters, all the user programmed filters are
266 NOTE: These filters use inverted masks.
269 NOTE: These filters use inverted masks.
363 Note that ICMP headers are parsed as 4 bytes of header and 4 bytes of payload.
365 the offset. Also note that ip4 filters match both ICMP frames as well as raw
463 NOTE: This command will disable ntuple filters and clear any aRFS filters in
499 Note: You cannot use SR-IOV when link aggregation (LAG)/bonding is active, and
509 NOTE: The output of this command can be very large due to the maximum number of
543 Note: If the command does not work, it may not be supported by your system.
558 NOTE: Assigning a MAC address for a VF from the host will disable any
574 NOTE: It's important to set the VF to trusted before setting promiscuous mode.
592 NOTE: By default, the ethtool private flag vf-true-promisc-support is set to
601 get when you enable promiscuous mode using the ip link commands above. Note
611 Note that the order in which you set the VF to promiscuous mode and add the
642 NOTE: This feature can be disabled for a specific VF::
665 NOTE: The maximum MTU setting for jumbo frames is 9702. This corresponds to the
668 NOTE: This driver will attempt to use multiple page sized buffers to receive
672 NOTE: Packet loss may have a greater impact on throughput when you use jumbo
712 NOTE: The kernel assumes that TC0 is available, and will disable Priority Flow
743 NOTE:
775 NOTE: You must enable the UEFI HII "LLDP Agent" attribute for this setting to
788 NOTE: You must have a flow control capable link partner.
798 Note: This command only enables or disables Flow Control if auto-negotiation is
802 Note: Flow Control auto-negotiation is part of link auto-negotiation. Depending
805 NOTE:
832 NOTE:
896 NOTE: