Lines Matching +full:secure +full:- +full:regions
3 Contact: linux-scsi@vger.kernel.org
5 This file contains the auto-hibernate idle timer setting of a
6 UFS host controller. A value of '0' means auto-hibernate is not
11 10-bit values with a power-of-ten multiplier which allows a
114 Description: This file shows the secure removal type. This is one of
237 Description: This file shows number of secure write protect areas
248 written during the pre-soldering phase of the PSA flow.
279 Description: This file shows the MIPI M-PHY version number in BCD format.
359 Description: This file shows the maximum data-in buffer size. This
369 Description: This file shows the maximum data-out buffer size. This
399 Description: This file shows support for out-of-order data transfer.
439 Description: This file shows supported secure removal types. This is
461 enhanced type 1-4). This is one of the UFS geometry
472 enhanced type 1-4). This is one of the UFS geometry
896 load to all logical units in pre-soldering state.
1127 Description: This entry shows if preserve user-space was configured
1149 Description: This entry shows the total user-space decrease in shared
1276 01h 0% - 10% WriteBooster Buffer life time used
1278 0Ah 90% - 100% WriteBooster Buffer life time used
1296 enable it. The WriteBooster is enabled after power-on/reset,
1346 HPB Sub-Region size = 512B x 2^bHPBSubRegionSize
1354 Description: This entry shows the maximum number of active HPB regions that
1362 Description: This entry shows the maximum number of HPB regions assigned to
1377 Description: This entry shows the number of HPB pinned regions assigned to
1401 recommendations for activating sub-regions and/or inactivating region.
1408 Description: This entry shows the number of active sub-regions recommended by
1416 Description: This entry shows the number of inactive regions recommended by
1425 activating sub-regions recommended by response UPIUs.
1469 "to-be-activated" list. Since we reset the read counter upon
1476 Description: In host control mode, we think of the regions as "buckets".
1478 We use entries_per_srgn - the amount of blocks in a subregion as
1480 single-block reads. Once the bucket size is crossed, we trigger
1481 a normalization work - not only to avoid overflow, but mainly
1486 an active region has exhausted its reads - inactivate it.
1493 happening when the max-active-regions limit has been crossed.
1510 Description: In order not to hang on to "cold" regions, we inactivate
1512 time - read_timeout_ms. If read_timeout_ms has expired, and the
1516 region if it is clean - see read_timeout_expiries.
1522 just re-wind its timer for another spin. Do that as long as it