Lines Matching full:purpose

378 Purpose:  Stop sending a transmit BREAK signal
390 Purpose:  Clr the DTR output
402 Purpose:  Clr the RTS output
415 Purpose:  Clear any existing transmit software flow control off condition
427 Purpose:  Convert a controller number to controller structure pointer
436 Purpose:  Strobe the MUDBAC's End Of Interrupt bit.
444 Purpose:  Strobe the PCI End Of Interrupt bit.
464 Purpose:  Disable I/O access to an AIOP
477 Purpose:  Disable output flow control using CTS
489 Purpose:  Disable IXANY Software Flow Control
501 Purpose:  Disable parity
515 Purpose:  Disable RTS toggle
528 Purpose:  Disable Rx FIFO
540 Purpose:  Disable the Rx status mode
551 Purpose:  Disable transmit
567 Purpose:  Disable Tx Software Flow Control
579 Purpose:  Enable I/O access to an AIOP
592 Purpose:  Enable output flow control using CTS
604 Purpose:  Enable IXANY Software Flow Control
616 Purpose:  Enable parity
633 Purpose:  Enable RTS toggle
651 Purpose:  Enable Rx FIFO
663 Purpose:  Enable the receive processor
684 Purpose:  Enable the Rx status mode
696 Purpose:  Enable transmit
708 Purpose:  Enable Tx Software Flow Control
720 Purpose:  Get the AIOP interrupt status
732 Purpose:  Get the number of channels supported by an AIOP
742 Purpose:  Get a channel's interrupt identification byte
758 Purpose:  Get the number of a channel within an AIOP
768 Purpose:  Get the channel status
796 Purpose:  Get the low byte only of the channel status
824 Purpose:  Get the controller interrupt status
837 Purpose:  Get the controller interrupt status
854 Purpose:  Get the number of data bytes in the Rx FIFO
865 Purpose:  Get the number of data bytes in the Tx FIFO
876 Purpose:  Get the I/O address of a channel's TxRx Data register
885 Purpose:  Initialize a channel structure to it's default state.
902 Purpose:  Reset the AIOP by number
915 Purpose:  Send a transmit BREAK signal
927 Purpose:  Set baud rate
941 Purpose:  Set data bits to 7
953 Purpose:  Set data bits to 8
965 Purpose:  Set the DTR output
977 Purpose:  Set even parity
994 Purpose:  Set odd parity
1011 Purpose:  Set the RTS output
1024 Purpose:  Set the Rx FIFO trigger level
1050 Purpose:  Set stop bits to 1
1062 Purpose:  Set stop bits to 2
1074 Purpose:  Set the Tx XOFF flow control character
1087 Purpose:  Set the Tx XON flow control character
1100 Purpose:  Start a channel's receive processor
1112 Purpose:  Write a transmit data byte to a channel.