Lines Matching +full:pci +full:- +full:based
1 # SPDX-License-Identifier: GPL-2.0-only
24 If you want to use a SCSI hard disk, SCSI tape drive, SCSI CD-ROM or
65 comment "SCSI support type (disk, tape, CD-ROM)"
76 the IOMEGA ZIP drive, say Y and read the SCSI-HOWTO,
77 the Disk-HOWTO and the Multi-Disk-HOWTO, available from
79 CD-ROMs.
95 SCSI-HOWTO, available from
98 for SCSI CD-ROMs.
109 by SCSI, FireWire, USB or ATAPI, say Y and read the SCSI-HOWTO
110 and the CDROM-HOWTO at <http://www.tldp.org/docs.html#howto>.
112 Make sure to say Y or M to "ISO 9660 CD-ROM file system support".
122 If you want to use SCSI scanners, synthesizers or CD-writers or just
124 CD-ROMs or tapes, say Y here. These won't be supported by the kernel
128 For scanners, look at SANE (<http://www.sane-project.org/>). For CD
136 <file:Documentation/scsi/scsi-generic.rst> for more information.
149 don't need this for those tiny 6-slot cdrom changers. Media
152 here. Check <file:Documentation/scsi/scsi-changer.rst> for details.
210 busses in parallel, leading to a significant speed-up.
225 If you wish to export transport-specific information about
234 If you wish to export transport-specific information about
243 If you wish to export transport-specific information about
252 If you wish to export transport-specific information about
261 If you wish to export transport-specific information about
267 bool "SCSI low-level drivers"
295 http://open-iscsi.org
319 tristate "3ware 5/6/7/8xxx ATA-RAID support"
320 depends on PCI && SCSI
322 3ware is the only hardware ATA-Raid product in Linux to date.
329 <file:drivers/scsi/3w-xxxx.c>.
333 depends on PCI && SCSI
344 tristate "3ware 9xxx SATA-RAID support"
345 depends on PCI && SCSI
347 This driver supports the 9000 series 3ware SATA-RAID cards.
352 <file:drivers/scsi/3w-9xxx.c>.
355 tristate "3ware 97xx SAS/SATA-RAID support"
356 depends on PCI && SCSI
358 This driver supports the LSI 3ware 9750 6Gb/s SAS/SATA-RAID cards.
363 <file:drivers/scsi/3w-sas.c>.
367 depends on PCI && SCSI
380 This is a driver for the AHA-1510, AHA-1520, AHA-1522, and AHA-2825
381 SCSI host adapters. It also works for the AVA-1505, but the IRQ etc.
384 It is explained in section 3.3 of the SCSI-HOWTO, available from
396 3.4 of the SCSI-HOWTO, available from
410 3.5 of the SCSI-HOWTO, available from
420 depends on SCSI && PCI
438 depends on SCSI && PCI
447 depends on SCSI && PCI && VIRT_TO_BUS
449 This driver supports all of Adaptec's I2O based RAID controllers as
459 depends on ISA || EISA || PCI
471 depends on PCI && SCSI
474 This is an ARECA-maintained driver by Erich Chen.
490 depends on SCSI && PCI
500 depends on (PCI || ISA) && SCSI && ISA_DMA_API && VIRT_TO_BUS
503 Adapters. Consult the SCSI-HOWTO, available from
507 Note that support for FlashPoint is only available for 32-bit
515 depends on SCSI_BUSLOGIC && PCI
523 tristate "Mylex DAC960/DAC1100 PCI RAID Controller (Block Interface)"
524 depends on PCI
528 eXtremeRAID PCI RAID controllers. This driver supports the
529 older, block based interface.
538 tristate "Mylex DAC960/DAC1100 PCI RAID Controller (SCSI Interface)"
539 depends on PCI
544 eXtremeRAID PCI RAID controllers. This driver supports the
545 newer, SCSI-based interface only.
555 depends on PCI && SCSI && X86
572 tristate "Microsoft Hyper-V virtual storage driver"
577 Select this option to enable the Hyper-V virtual storage driver.
594 depends on PCI
601 depends on PCI && X86
604 This is support for the Cisco PCI-Express FCoE HBA.
612 depends on PCI && SCSI
614 This is support for the Cisco PCI-Express SCSI HBA.
629 depends on PCI && SCSI
642 tristate "Future Domain TMC-3260/AHA-2920A PCI SCSI support"
643 depends on PCI && SCSI
646 This is support for Future Domain's PCI SCSI host adapters (TMC-3260)
647 and other adapters with PCI bus based on the Future Domain chipsets
648 (Adaptec AHA-2920A).
650 NOTE: Newer Adaptec AHA-2920C boards use the Adaptec AIC-7850 chip
653 Adaptec AHA-2920A boards with a Future Domain chip on them.
664 This is support for Future Domain's 16-bit SCSI host adapters
665 (TMC-1660/1680, TMC-1650/1670, TMC-1610M/MER/MEX) and other adapters
666 with ISA bus based on the Future Domain chipsets (Quantum ISA-200S,
667 ISA-250MG; and at least one IBM board).
674 depends on PCI && SCSI
678 This is a driver for RAID/SCSI Disk Array Controllers (EISA/ISA/PCI)
688 depends on PCI && SCSI
700 This is a driver for old ISA card SCSI controllers based on a
703 various 8-bit and 16-bit ISA cards bundled with SCSI scanners.
710 depends on PCI && SCSI
714 and <http://www-947.ibm.com/support/entry/portal/docdisplay?brand=5000008&lndocid=SERV-RAID>
734 depends on PPC_PSERIES && TARGET_CORE && SCSI && PCI
770 depends on PCI && SCSI
773 read the SCSI-HOWTO, available from
780 tristate "Initio INI-A100U2W support"
781 depends on PCI && SCSI
783 This is support for the Initio INI-A100U2W SCSI host adapter.
784 Please read the SCSI-HOWTO, available from
791 tristate "IOMEGA parallel port (ppa - older drives)"
803 then you should say N here and Y to "IOMEGA parallel port (imm -
808 the SCSI-HOWTO, which is available from
818 tristate "IOMEGA parallel port (imm - newer drives)"
831 here and Y to "IOMEGA Parallel Port (ppa - older drives)", above.
835 the SCSI-HOWTO, which is available from
845 bool "ppa/imm option - Use slow (but safe) EPP-16"
860 bool "ppa/imm option - Assume slow parport control register"
879 many PA-RISC workstations & servers. If you do not know whether you
898 depends on PCI && SCSI
915 depends on PCI && SCSI
919 PCI-SCSI controllers. It also supports the subset of LSI53C10XX
920 Ultra-160 controllers that are based on the SYM53C8XX SCRIPTS
921 language. It does not support LSI53C10XX Ultra-320 PCI-X SCSI
932 This option only applies to PCI-SCSI chips that are PCI DAC
933 capable (875A, 895A, 896, 1010-33, 1010-66, 1000).
936 32-bit DMA. When set to 1, the chip will be able to perform DMA
938 full 64-bit DMA address range, but can only address 16 segments
947 PCI address bits past bit 39 to be set for the addressing of
948 memory using PCI DAC cycles.
969 This value is used as a compiled-in hard limit.
982 depends on PCI && SCSI && ATA
1016 PA-RISC processor and the NCR 53c720 SCSI controller on C100,
1017 C110, J200, J210 and some D, K & R-class machines. It's also
1018 used on the add-in Bluefish, Barracuda & Shrike SCSI cards.
1026 "Tagged command queuing" is a feature of SCSI-2 which improves
1030 (like head positioning) based on its own request queue. Some SCSI
1069 The SCSI Parallel Interface-2 Standard defines 5 classes of transfer
1070 rates: FAST-5, FAST-10, FAST-20, FAST-40 and FAST-80. The numbers
1071 are respectively the maximum data transfer rates in mega-transfers
1072 per second for each class. For example, a FAST-20 Wide 16 device is
1084 since the driver will get this information from the user set-up. It
1087 for FAST-20 synchronous data transfer (20 mega-transfers per
1103 device of yours to not support properly the target-disconnect
1113 FastSCSI! cards as well as any other card based on the FASXX chip
1116 This driver does NOT support the PCI versions of these cards. The
1117 PCI versions are supported by the Qlogic ISP driver ("Qlogic ISP
1122 SCSI-HOWTO, available from
1130 depends on PCI && SCSI
1143 PTI,ptisp or QLGC,isp. Note that PCI QLogic SCSI controllers are
1156 depends on PCI && SCSI
1164 Family of Fibre Channel PCI host adapters.
1178 This driver is for NCR53c710 based SCSI host adapters.
1184 depends on PCI && SCSI
1186 This driver supports PCI SCSI host adapters based on the ASIC
1187 TRM-S1040 chip, e.g Tekram DC395(U/UW/F) and DC315(U) variants.
1199 depends on PCI && SCSI
1202 This driver supports PCI SCSI host adapters based on the Am53C974A
1208 based on NCR/Symbios chips. Use "NCR53C8XX SCSI support" for those.
1214 tristate "Workbit NinjaSCSI-32Bi/UDE support"
1215 depends on PCI && SCSI && !64BIT
1217 This is support for the Workbit NinjaSCSI-32Bi/UDE PCI/Cardbus
1218 SCSI host adapter. Please read the SCSI-HOWTO, available from
1226 depends on PCI && SCSI
1229 This is a driver for Western Digital WD7193, WD7197 and WD7296 PCI
1230 SCSI controllers (based on WD33C296A chip).
1296 4000, Acer PICA, Olivetti M700-10 and a few other identical OEM
1304 built-in SCSI controller, say Y. Otherwise, say N.
1326 answer N. This driver does NOT work for the T-Rex series of
1327 accelerators from TekMagic and GVP-M.
1338 built-in SCSI controller, say Y. Otherwise, say N.
1348 Support for various NCR53c710-based SCSI controllers on Zorro
1351 - the Amiga 4091 Zorro III SCSI-2 controller,
1352 - the MacroSystem Development's WarpEngine Amiga SCSI-2 controller
1355 - the SCSI controller on the Phase5 Blizzard PowerUP 603e+
1357 - the SCSI controller on the GVP Turbo 040/060 accelerator.
1365 Support for various NCR53C9x (ESP) based SCSI controllers on Zorro
1368 - the Phase5 Blizzard 1230 II and IV SCSI controllers,
1369 - the Phase5 Blizzard 2060 SCSI controller,
1370 - the Phase5 Blizzard Cyberstorm and Cyberstorm II SCSI
1372 - the Fastlane Zorro III SCSI controller.
1379 If you have an Atari with built-in NCR5380 SCSI controller (TT,
1389 ST-DMA, replacing ACSI). It does NOT support other schemes, like
1398 based Macintoshes. If you have one of these say Y and read the
1399 SCSI-HOWTO, available from
1409 based Macintoshes.
1419 Support for the on-board SCSI controller on the Motorola MVME147
1420 single-board computer.
1447 "Sun3" type VME scsi controllers also based on the NCR5380.
1456 The ESP was an on-board SCSI controller used on Sun 3/80
1465 chipset is present in most SPARC SBUS-based computers and
1485 Commands", SC33-8411.
1493 depends on PCI && SCSI && NET
1499 tristate "PMC-Sierra SPC 8001 SAS/SATA Based Host Adapter driver"
1500 depends on PCI && SCSI
1503 This driver supports PMC-Sierra PCIE SAS/SATA 8x6G SPC 8001 chip
1504 based host adapters.
1508 depends on PCI && SCSI
1517 tristate "virtio-scsi support"