Lines Matching +full:default +full:- +full:on

1 # SPDX-License-Identifier: GPL-2.0-only
7 	default y if ARCH_HAS_RESET_CONTROLLER
12 	  via GPIOs or SoC-internal reset controller modules.
20 	depends on MFD_ALTERA_A10SR
23 	  peripheral PHYs on the Altera Arria10 System Resource Chip.
27 	default ATH79
34 	default ARC_PLAT_AXS10X
40 	default ARCH_BERLIN
46 	depends on ARCH_BRCMSTB || COMPILE_TEST
47 	default ARCH_BRCMSTB
54 	depends on HAS_IOMEM
55 	default ARCH_BRCMSTB || COMPILE_TEST
57 	  This enables the RESCAL reset controller for SATA, PCIe0, or PCIe1 on
62 	depends on HAS_IOMEM
63 	depends on ARC_SOC_HSDK || COMPILE_TEST
69 	depends on HAS_IOMEM
70 	depends on SOC_IMX7D || (ARM64 && ARCH_MXC) || COMPILE_TEST
71 	default y if SOC_IMX7D
78 	depends on OF && HAS_IOMEM
87 	default SOC_TYPE_XWAY
93 	default ARCH_LPC18XX
99 	default ARCH_MESON
105 	depends on ARCH_MESON || COMPILE_TEST
112 	default ARCH_NPCM
122 	default MACH_PISTACHIO
128 	depends on ARCH_QCOM || COMPILE_TEST
130 	  This enables the AOSS (always on subsystem) reset driver
137 	depends on ARCH_QCOM || COMPILE_TEST
146 	depends on RASPBERRYPI_FIRMWARE || (RASPBERRYPI_FIRMWARE=n && COMPILE_TEST)
147 	default USB_XHCI_PCI
149 	  Raspberry Pi 4's co-processor controls some of the board's HW
152 	  interfacing with RPi4's co-processor and model these firmware
157 	depends on ARM_SCMI_PROTOCOL || COMPILE_TEST
158 	default ARM_SCMI_PROTOCOL
168 …default ARCH_AGILEX || ARCH_ASPEED || ARCH_BITMAIN || ARCH_REALTEK || ARCH_STM32 || ARCH_STRATIX10…
175 	   - Altera SoCFPGAs
176 	   - ASPEED BMC SoCs
177 	   - Bitmain BM1880 SoC
178 	   - Realtek SoCs
179 	   - RCC reset controller in STM32 MCUs
180 	   - Allwinner SoCs
181 	   - ZTE's zx2967 family
185 	default MACH_STM32MP157
191 	default ARCH_SOCFPGA
199 	default ARCH_SUNXI
205 	tristate "TI System Control Interface (TI-SCI) reset driver"
206 	depends on TI_SCI_PROTOCOL
209 	  available on some new TI's SoCs. If you wish to use reset resources
214 	depends on HAS_IOMEM
218 	  memory-mapped reset registers as part of a syscon device node. If
219 	  you wish to use the reset framework for such memory-mapped devices,
224 	depends on ARCH_UNIPHIER || COMPILE_TEST
225 	depends on OF && MFD_SYSCON
226 	default ARCH_UNIPHIER
228 	  Support for reset controllers on UniPhier SoCs.
234 	depends on (ARCH_UNIPHIER || COMPILE_TEST) && OF
235 	default ARCH_UNIPHIER
239 	  on UniPhier SoCs. Say Y if you want to control reset signals
244 	default ARCH_ZYNQ