Lines Matching +full:ocelot +full:- +full:i2c
1 # SPDX-License-Identifier: GPL-2.0-only
35 bool "Axis ARTPEC-6 pin controller driver"
40 This is the driver for the Axis ARTPEC-6 pin controller. This driver
43 found in Documentation/devicetree/bindings/pinctrl/axis,artpec6-pinctrl.txt
52 functionality. This driver supports the pinmux, push-pull and
57 tristate "X-Powers AXP209 PMIC pinctrl and GPIO Support"
122 tristate "TI DA850/OMAP-L138/AM18XX pullup/pulldown groups"
127 Driver for TI DA850/OMAP-L138/AM18XX pinconf. Used to control
186 depends on SPI_MASTER || I2C
190 select PINCTRL_MCP23S08_I2C if I2C
193 SPI/I2C driver for Microchip MCP23S08 / MCP23S17 / MCP23S18 /
196 corresponding interrupt-controller.
219 tristate "One-register-per-pin type device tree based pinctrl driver"
237 bool "Semtech SX150x I2C GPIO expander pinctrl driver"
238 depends on I2C=y
246 Say yes here to provide support for Semtech SX150x-series I2C
249 - 8 bits: sx1508q, sx1502q
250 - 16 bits: sx1509q, sx1506q
269 depends on I2C
275 Driver for STMicroelectronics Multi-Function eXpander (STMFX)
278 and configuring push-pull, open-drain, and can also be used as
279 interrupt-controller.
288 bool "ST-Ericsson U300 COH 901 335/571 GPIO"
292 Say yes here to support GPIO interface on ST-Ericsson U300.
305 function in alternate mode. This driver also configure push-pull,
315 functionality. This driver supports the pinmux, push-pull and
366 bool "Pinctrl driver for the Microsemi Ocelot and Jaguar2 SoCs"