Lines Matching +full:multi +full:- +full:functional
1 # SPDX-License-Identifier: GPL-2.0-only
44 tristate "Active-semi ACT8945A"
49 Support for the ACT8945A PMIC from Active-semi. This device
50 features three step-down DC/DC converters and four low-dropout
66 sun4i-gpadc-iio and the hwmon driver iio_hwmon.
69 called sun4i-gpadc.
88 tablets etc. It has 4 DC/DC step-down regulators, 3 DC/DC step-down
119 over at91-usart-serial driver and usart-spi-driver. Only one function
135 tristate "Atmel HLCDC (High-end LCD Controller)"
172 tristate "X-Powers AC100"
176 If you say Y here you get support for the X-Powers AC100 audio codec
187 tristate "X-Powers AXP series PMICs with I2C"
192 If you say Y here you get support for the X-Powers AXP series power
204 tristate "X-Powers AXP series PMICs with RSB"
208 If you say Y here you get support for the X-Powers AXP series power
221 sub-devices. This driver will instantiate additional drivers such
225 called cros-ec-dev.
306 usually found on PXA processors-based platforms. This includes
309 LEDs and battery-charger under the corresponding menus.
381 tristate "Dialog Semiconductor DA9150 Charger Fuel-Gauge chip"
387 This adds support for the DA9150 integrated charger and fuel-gauge
397 This adds support for Diolan USB-I2C/SPI/GPIO Master Adapter
398 DLN-2. Additional drivers such as I2C_DLN2, GPIO_DLN2,
408 This adds support for the power-off functionality and access to
431 such as push-button monitor, multiple ADC's for voltage and
480 Analog-to-Digital Converter (LRADC) found on the i.MX23 and i.MX28
484 mxs-lradc-adc for ADC readings
485 mxs-lradc-ts for touchscreen support
488 called mxs-lradc.
505 Add support for HiSilicon Hi6421 PMIC. Hi6421 includes multi-
510 We communicate with the Hi6421 via memory-mapped I/O.
529 handled by the leds-pasic3 and ds1wm drivers.
538 interface to one or more sub-chips.
550 The GPIO exports a total amount of 8 interrupt-capable GPIOs.
558 many functional units. This driver provides needed support for
586 causes the designware-i2c driver to be builtin for the same reason.
613 causes the designware-i2c driver to be builtin for the same reason.
650 I2C, SPI and HS-UART starting from Intel Sunrisepoint (Intel Skylake
659 I2C, SPI and HS-UART starting from Intel Sunrisepoint (Intel Skylake
681 multi-function device that exposes IPC, General Control
682 Register and P-unit access. In addition this creates devices
702 IQS621, IQS622, IQS624 and IQS625 multi-function sensors. Additional
703 options must be selected to enable device-specific functions.
709 tristate "Janz CMOD-IO PCI MODULbus Carrier Board"
713 This is the core driver for the Janz CMOD-IO PCI MODULbus
727 * COMe-bBD#
728 * COMe-bBL6
729 * COMe-bHL6
730 * COMe-bSL6
731 * COMe-bIP#
732 * COMe-bKL6
733 * COMe-bPC2 (ETXexpress-PC)
734 * COMe-bSC# (ETXexpress-SC T#)
735 * COMe-cAL6
736 * COMe-cBL6
737 * COMe-cBT6
738 * COMe-cBW6
739 * COMe-cCT6
740 * COMe-cDC2 (microETXexpress-DC)
741 * COMe-cHL6
742 * COMe-cKL6
743 * COMe-cPC2 (microETXexpress-PC)
744 * COMe-cSL6
745 * COMe-mAL10
746 * COMe-mBT10
747 * COMe-mCT10
748 * COMe-mTT10 (nanoETXexpress-TT)
749 * ETX-OH
752 will be called kempld-core.
764 battery-charger under the corresponding menus.
787 battery-charger under the corresponding menus.
798 MAX77836 Micro-USB ICs with battery charger.
930 Say Y here to enable MT6360 PMU/PMIC/LDO functional support.
932 PMIC part includes 2-channel BUCKs and 2-channel LDOs
933 LDO part includes 4-channel LDOs
952 The device supports multiple sub-devices like LED, HWMON and WDT.
994 tristate "Nokia Retu and Tahvo multi-function device"
999 Retu and Tahvo are a multi-function devices found on Nokia
1010 so that function-specific drivers can bind to them.
1045 built-in PM8xxx PMIC chips.
1051 module. This will build a module called "pm8xxx-core".
1080 series as a module. The module will be called "qcom-spmi-pmic".
1083 tristate "RDC R-321x southbridge"
1087 Say yes here if you want to have support for the RDC R-321x SoC
1101 sub-devices like charger, fuel gauge, flash LED, current source,
1113 through i2c interface. The device supports multiple sub-devices
1128 through I2C interface. The device supports multiple sub-devices
1159 module will be called sec-core.
1171 radio. This MFD driver connects the radio-si476x V4L2 module
1175 module will be called si476x-core.
1183 to be shared by all sub-devices.
1186 sub-devices represented by child nodes in Device Tree will be
1198 * SMARC-sAL28
1248 bool "ST-Ericsson ABX500 Mixed Signal Circuit register functions"
1258 bool "ST-Ericsson AB3100 Mixed Signal Circuit core functions"
1267 this multi-functional IC. This is needed to use other features
1268 of the AB3100 such as battery-backed RTC, charging control,
1273 tristate "ST-Ericsson AB3100 OTP functions"
1277 Select this to enable the AB3100 Mixed Signal IC OTP (one-time
1282 bool "ST-Ericsson AB8500 Mixed Signal Power Management chip"
1303 bool "ST-Ericsson DB8500 Power Reset Control Management Unit"
1333 GPIO: stmpe-gpio
1334 Keypad: stmpe-keypad
1335 Touchscreen: stmpe-ts
1336 ADC: stmpe-adc
1460 high-power "white LED driver". This boost converter is
1551 designware-i2c driver to be built-in, for the same reason.
1657 step-down converters, 11 general purpose LDOs, USB OTG Module,
1670 so that function-specific drivers can bind to them.
1672 These multi-function chips are found on many OMAP2 and OMAP3
1686 This driver uses board-specific data to initialize the resources
1716 regulators, Dual slot memory card transceivers, real-time clock
1727 driver connects the radio-wl1273 V4L2 module and the wl1273
1741 backlight or ambient-light-sensor functionality of the device.
1752 for in-vehicle infontainment, called Russellville.
1796 tristate "TQ-Systems IO controller TQMX86"
1800 TQ-Systems IO controller and watchdog device, found on their
1937 The WM8994 is a highly integrated hi-fi CODEC designed for
1951 The WM9705, WM9712 and WM9713 is a highly integrated hi-fi CODEC
1965 in various ST Microelectronics and ST-Ericsson embedded
1990 Management IC. BD71837 is general purpose single-chip power
1991 management IC for battery-powered portable devices. It contains
1992 3 ultra-low current consumption buck converters, 3 LDOs and 2 LED
1993 drivers. Also included are 4 GPIOs, a real-time clock (RTC), a 32kHz
1994 crystal oscillator, high-accuracy VREF for use with an external ADC,
2007 Management IC. BD71828GW is a single-chip power management IC for
2008 battery-powered portable devices. The IC integrates 7 buck
2009 converters, 7 LDOs, and a 1500 mA single-cell linear charger.
2010 Also included is a Coulomb counter, a real-time clock (RTC), and
2014 tristate "Support for STM32 Low-Power Timer"
2020 Select this option to enable STM32 Low-Power Timer driver
2025 module will be called stm32-lptimer.
2055 tristate "Support for STMicroelectronics Multi-Function eXpander (STMFX)"
2061 Support for the STMicroelectronics Multi-Function eXpander.
2093 power-on options, power-off control and system FAN control on recent
2148 This option enables basic support for the SGI IOC3-based