Lines Matching +full:gpio +full:- +full:charger
1 # SPDX-License-Identifier: GPL-2.0-only
20 necessary for using the board's GPIO and MFGPT functionality.
30 accessing the external gpio extender (LEDs & buttons) and
44 tristate "Active-semi ACT8945A"
49 Support for the ACT8945A PMIC from Active-semi. This device
50 features three step-down DC/DC converters and four low-dropout
52 charger.
66 sun4i-gpadc-iio and the hwmon driver iio_hwmon.
69 called sun4i-gpadc.
88 tablets etc. It has 4 DC/DC step-down regulators, 3 DC/DC step-down
119 over at91-usart-serial driver and usart-spi-driver. Only one function
135 tristate "Atmel HLCDC (High-end LCD Controller)"
165 voltage regulator, voltage sampling units, GPIO block and
172 tristate "X-Powers AC100"
176 If you say Y here you get support for the X-Powers AC100 audio codec
187 tristate "X-Powers AXP series PMICs with I2C"
192 If you say Y here you get support for the X-Powers AXP series power
204 tristate "X-Powers AXP series PMICs with RSB"
208 If you say Y here you get support for the X-Powers AXP series power
221 sub-devices. This driver will instantiate additional drivers such
225 called cros-ec-dev.
306 usually found on PXA processors-based platforms. This includes
309 LEDs and battery-charger under the corresponding menus.
381 tristate "Dialog Semiconductor DA9150 Charger Fuel-Gauge chip"
387 This adds support for the DA9150 integrated charger and fuel-gauge
397 This adds support for Diolan USB-I2C/SPI/GPIO Master Adapter
398 DLN-2. Additional drivers such as I2C_DLN2, GPIO_DLN2,
408 This adds support for the power-off functionality and access to
431 such as push-button monitor, multiple ADC's for voltage and
465 tristate "Monolithic Power Systems MP2629 ADC and Battery charger"
470 battery charger. This provides ADC, thermal and battery charger power
480 Analog-to-Digital Converter (LRADC) found on the i.MX23 and i.MX28
484 mxs-lradc-adc for ADC readings
485 mxs-lradc-ts for touchscreen support
488 called mxs-lradc.
505 Add support for HiSilicon Hi6421 PMIC. Hi6421 includes multi-
510 We communicate with the Hi6421 via memory-mapped I/O.
529 handled by the leds-pasic3 and ds1wm drivers.
538 interface to one or more sub-chips.
541 tristate "Intel Quark MFD I2C GPIO"
547 This MFD provides support for I2C and GPIO that exist only
550 The GPIO exports a total amount of 8 interrupt-capable GPIOs.
559 other drivers to control these functions, currently GPIO and
580 on some Intel SoC systems. The PMIC provides ADC, GPIO,
581 thermal, charger and related power management functions
586 causes the designware-i2c driver to be builtin for the same reason.
595 on Intel Broxton systems. The PMIC provides ADC, GPIO,
596 thermal, charger and related power management functions
613 causes the designware-i2c driver to be builtin for the same reason.
650 I2C, SPI and HS-UART starting from Intel Sunrisepoint (Intel Skylake
659 I2C, SPI and HS-UART starting from Intel Sunrisepoint (Intel Skylake
668 Passage) chip. This chip embeds audio, battery, GPIO, etc.
681 multi-function device that exposes IPC, General Control
682 Register and P-unit access. In addition this creates devices
702 IQS621, IQS622, IQS624 and IQS625 multi-function sensors. Additional
703 options must be selected to enable device-specific functions.
709 tristate "Janz CMOD-IO PCI MODULbus Carrier Board"
713 This is the core driver for the Janz CMOD-IO PCI MODULbus
716 CAN and GPIO controllers.
724 device may provide functions like watchdog, GPIO, UART and I2C bus.
727 * COMe-bBD#
728 * COMe-bBL6
729 * COMe-bHL6
730 * COMe-bSL6
731 * COMe-bIP#
732 * COMe-bKL6
733 * COMe-bPC2 (ETXexpress-PC)
734 * COMe-bSC# (ETXexpress-SC T#)
735 * COMe-cAL6
736 * COMe-cBL6
737 * COMe-cBT6
738 * COMe-cBW6
739 * COMe-cCT6
740 * COMe-cDC2 (microETXexpress-DC)
741 * COMe-cHL6
742 * COMe-cKL6
743 * COMe-cPC2 (microETXexpress-PC)
744 * COMe-cSL6
745 * COMe-mAL10
746 * COMe-mBT10
747 * COMe-mCT10
748 * COMe-mTT10 (nanoETXexpress-TT)
749 * ETX-OH
752 will be called kempld-core.
764 battery-charger under the corresponding menus.
787 battery-charger under the corresponding menus.
790 tristate "Maxim Semiconductor MAX14577/77836 MUIC + Charger Support"
798 MAX77836 Micro-USB ICs with battery charger.
830 the following functionalities of the device: GPIO, regulator,
831 charger, LED, onkey.
856 This is a companion Power Management IC with Flash, Haptic, Charger,
870 This is companion Power Management IC with LEDs, Haptic, Charger,
931 PMU part includes Charger, Flashlight, RGB LED
932 PMIC part includes 2-channel BUCKs and 2-channel LDOs
933 LDO part includes 4-channel LDOs
952 The device supports multiple sub-devices like LED, HWMON and WDT.
994 tristate "Nokia Retu and Tahvo multi-function device"
999 Retu and Tahvo are a multi-function devices found on Nokia
1010 so that function-specific drivers can bind to them.
1020 tristate "NXP PCF50633 GPIO"
1023 Say yes here if you want to include support GPIO for pins on
1045 built-in PM8xxx PMIC chips.
1051 module. This will build a module called "pm8xxx-core".
1080 series as a module. The module will be called "qcom-spmi-pmic".
1083 tristate "RDC R-321x southbridge"
1087 Say yes here if you want to have support for the RDC R-321x SoC
1101 sub-devices like charger, fuel gauge, flash LED, current source,
1113 through i2c interface. The device supports multiple sub-devices
1114 like GPIO, interrupts, RTC, LDO and DCDC regulators, onkey.
1128 through I2C interface. The device supports multiple sub-devices
1159 module will be called sec-core.
1171 radio. This MFD driver connects the radio-si476x V4L2 module
1175 module will be called si476x-core.
1183 to be shared by all sub-devices.
1186 sub-devices represented by child nodes in Device Tree will be
1198 * SMARC-sAL28
1212 bool "Export GPIO via GPIO layer"
1215 This option uses the gpio library layer to export the 64 GPIO
1217 base number for the first GPIO line to register.
1248 bool "ST-Ericsson ABX500 Mixed Signal Circuit register functions"
1258 bool "ST-Ericsson AB3100 Mixed Signal Circuit core functions"
1267 this multi-functional IC. This is needed to use other features
1268 of the AB3100 such as battery-backed RTC, charging control,
1273 tristate "ST-Ericsson AB3100 OTP functions"
1277 Select this to enable the AB3100 Mixed Signal IC OTP (one-time
1282 bool "ST-Ericsson AB8500 Mixed Signal Power Management chip"
1303 bool "ST-Ericsson DB8500 Power Reset Control Management Unit"
1323 STMPE811: GPIO, Touchscreen, ADC
1324 STMPE1601: GPIO, Keypad
1325 STMPE1801: GPIO, Keypad
1326 STMPE2401: GPIO, Keypad
1327 STMPE2403: GPIO, Keypad
1333 GPIO: stmpe-gpio
1334 Keypad: stmpe-keypad
1335 Touchscreen: stmpe-ts
1336 ADC: stmpe-adc
1407 This driver consists of GPIO and PWM drivers.
1409 general usage such like a GPIO controller and a PWM controller.
1418 TI LP8788 PMU supports regulators, battery charger, RTC,
1460 high-power "white LED driver". This boost converter is
1462 also contains a GPIO pin.
1529 charger, wled and other features that are often used in portable
1551 designware-i2c driver to be built-in, for the same reason.
1590 These include voltage regulators, gpio and other features
1656 Path and Battery Charger. The device provides five configurable
1657 step-down converters, 11 general purpose LDOs, USB OTG Module,
1658 ADC, RTC, 2 PWM, System Voltage Regulator/Battery Charger with
1670 so that function-specific drivers can bind to them.
1672 These multi-function chips are found on many OMAP2 and OMAP3
1673 boards, providing power management, RTC, GPIO, keypad, a
1686 This driver uses board-specific data to initialize the resources
1716 regulators, Dual slot memory card transceivers, real-time clock
1727 driver connects the radio-wl1273 V4L2 module and the wl1273
1741 backlight or ambient-light-sensor functionality of the device.
1752 for in-vehicle infontainment, called Russellville.
1796 tristate "TQ-Systems IO controller TQMX86"
1800 TQ-Systems IO controller and watchdog device, found on their
1937 The WM8994 is a highly integrated hi-fi CODEC designed for
1939 has on board GPIO and regulator functionality which is
1951 The WM9705, WM9712 and WM9713 is a highly integrated hi-fi CODEC
1953 it has on board GPIO and a touchscreen functionality which is
1965 in various ST Microelectronics and ST-Ericsson embedded
1990 Management IC. BD71837 is general purpose single-chip power
1991 management IC for battery-powered portable devices. It contains
1992 3 ultra-low current consumption buck converters, 3 LDOs and 2 LED
1993 drivers. Also included are 4 GPIOs, a real-time clock (RTC), a 32kHz
1994 crystal oscillator, high-accuracy VREF for use with an external ADC,
1996 charger.
2007 Management IC. BD71828GW is a single-chip power management IC for
2008 battery-powered portable devices. The IC integrates 7 buck
2009 converters, 7 LDOs, and a 1500 mA single-cell linear charger.
2010 Also included is a Coulomb counter, a real-time clock (RTC), and
2014 tristate "Support for STM32 Low-Power Timer"
2020 Select this option to enable STM32 Low-Power Timer driver
2025 module will be called stm32-lptimer.
2055 tristate "Support for STMicroelectronics Multi-Function eXpander (STMFX)"
2061 Support for the STMicroelectronics Multi-Function eXpander.
2093 power-on options, power-off control and system FAN control on recent
2148 This option enables basic support for the SGI IOC3-based