Lines Matching +full:suspend +full:- +full:to +full:- +full:ram

1 # SPDX-License-Identifier: GPL-2.0-only
9 	  This option allows to enable specific memory controller drivers,
12 	  vary from memory tuning and frequency scaling to enabling
13 	  access to attached peripherals through memory bus.
34 	bool "Atmel (Multi-port DDR-)SDRAM Controller"
39 	  This driver is for Atmel SDRAM Controller or Atmel Multi-port
40 	  DDR-SDRAM Controller available on Atmel AT91SAM9 and SAMA5 SoCs.
42 	  LP-DDR memories.
53 	  Used to configure the EBI (external bus interface) when the device-
62 	  This driver provides access to the DPFE interface of Broadcom
64 	  provide current information about the system's RAM, for instance
66 	  for the DRAM's temperature. Slower refresh rate means cooler RAM,
67 	  higher refresh rate means hotter RAM.
70 	bool "Baikal-T1 CM2 L2-RAM Cache Control Block"
74 	  Baikal-T1 CPU is based on the MIPS P5600 Warrior IP-core. The CPU
75 	  resides Coherency Manager v2 with embedded 1MB L2-cache. It's
76 	  possible to tune the L2 cache performance up by setting the data,
77 	  tags and way-select latencies of RAM access. This driver provides a
78 	  dt properties-based and sysfs interface for it.
87 	  is intended to provide a glue-less interface to a variety of
101 	  functions of the driver includes re-configuring AC timing
112 	  interfacing to a variety of asynchronous as well as synchronous
119 	  Enables verbose debugging mostly to decode the bootloader provided
120 	  timings. To preserve the bootloader provided timings, the reset
121 	  of GPMC is skipped during init. Enable this during development to
122 	  configure devices connected to the GPMC bus.
124 	  NOTE: In addition to matching the register setup with the bootloader
125 	  you also need to match the GPMC FCLK frequency used by the
136 	  the EMIF PM code must run from on-chip SRAM late in the suspend
138 	  for the SoC PM code to use.
148 	  Armada 370 and Armada XP. This controller allows to handle flash
156 	  Coherency Fabric.  Errors reported include accesses to
172 	  the Ingenic JZ4780. This controller is used to handle external
188 	  Texas Instruments da8xx SoCs. It's used to tweak various memory
201 	tristate "Renesas RPC-IF driver"
205 	  This supports Renesas R-Car Gen3 RPC-IF which provides either SPI
206 	  host or HyperFlash. You'll have to select individual components
214 	  Select this option to enable the STM32 FMC2 External Bus Interface