Lines Matching +full:fixed +full:- +full:frequency
1 // SPDX-License-Identifier: GPL-2.0
6 #include <dt-bindings/gpio/gpio.h>
21 compatible = "fixed-clock";
22 #clock-cells = <0>;
23 clock-frequency = <32768>;
24 clock-output-names = "osc_32k";
28 compatible = "regulator-fixed";
29 regulator-name = "fixed-1.8V";
30 regulator-min-microvolt = <1800000>;
31 regulator-max-microvolt = <1800000>;
32 regulator-boot-on;
33 regulator-always-on;
37 compatible = "regulator-fixed";
38 regulator-name = "fixed-3.3V";
39 regulator-min-microvolt = <3300000>;
40 regulator-max-microvolt = <3300000>;
41 regulator-boot-on;
42 regulator-always-on;
46 compatible = "mmc-pwrseq-simple";
47 reset-gpios = <&pca9654 1 GPIO_ACTIVE_LOW>;
49 clock-names = "ext_clock";
50 post-power-on-delay-ms = <80>;
55 pinctrl-0 = <&avb_pins>;
56 pinctrl-names = "default";
57 phy-handle = <&phy0>;
58 phy-mode = "rgmii-id";
61 phy0: ethernet-phy@0 {
63 interrupt-parent = <&gpio2>;
65 reset-gpios = <&gpio2 10 GPIO_ACTIVE_LOW>;
70 clock-frequency = <16666666>;
74 clock-frequency = <32768>;
79 gpio-hog;
81 output-high;
82 line-name = "usb-hub-reset";
87 pinctrl-0 = <&hscif0_pins>;
88 pinctrl-names = "default";
89 uart-has-rtscts;
91 max-speed = <4000000>;
94 compatible = "brcm,bcm43438-bt";
95 shutdown-gpios = <&pca9654 2 GPIO_ACTIVE_HIGH>;
96 host-wakeup-gpios = <&gpio1 28 GPIO_ACTIVE_HIGH>;
97 device-wakeup-gpios = <&pca9654 5 GPIO_ACTIVE_HIGH>;
99 clock-names = "extclk";
105 pinctrl-0 = <&hscif2_pins>;
106 pinctrl-names = "default";
111 clock-frequency = <400000>;
116 gpio-controller;
117 #gpio-cells = <2>;
118 gpio-line-names =
132 interrupt-parent = <&gpio5>;
134 interrupt-controller;
135 #interrupt-cells = <2>;
136 gpio-controller;
137 #gpio-cells = <2>;
138 gpio-line-names =
152 read-only; /* Manufacturing EEPROM programmed at factory */
164 #clock-cells = <1>;
166 clock-names = "xin";
168 assigned-clocks = <&versaclock5 1>,
172 assigned-clock-rates = <33333333>, <33333333>, <50000000>, <125000000>;
177 pinctrl-0 = <&scif_clk_pins>;
178 pinctrl-names = "default";
188 drive-strength = <24>;
194 drive-strength = <12>;
241 power-source = <1800>;
247 power-source = <1800>;
252 clock-frequency = <14745600>;
256 pinctrl-0 = <&scif2_pins>;
257 pinctrl-names = "default";
262 pinctrl-names = "default";
263 pinctrl-0 = <&sdhi2_pins>;
264 bus-width = <4>;
265 vmmc-supply = <®_3p3v>;
266 vqmmc-supply = <®_1p8v>;
267 non-removable;
268 cap-power-off-card;
269 pm-ignore-notify;
270 keep-power-in-suspend;
271 mmc-pwrseq = <&wlan_pwrseq>;
273 #address-cells = <1>;
274 #size-cells = <0>;
278 compatible = "brcm,bcm4329-fmac";
279 interrupt-parent = <&gpio1>;
281 interrupt-names = "host-wake";
286 pinctrl-0 = <&sdhi3_pins>;
287 pinctrl-1 = <&sdhi3_pins>;
288 pinctrl-names = "default", "state_uhs";
289 vmmc-supply = <®_3p3v>;
290 vqmmc-supply = <®_1p8v>;
291 bus-width = <8>;
292 mmc-hs200-1_8v;
293 non-removable;
294 fixed-emmc-driver-type = <1>;
299 clock-frequency = <50000000>;
303 clock-frequency = <100000000>;