Lines Matching +full:button +full:-

1 // SPDX-License-Identifier: GPL-2.0
3  * arch/arm/mach-ixp4xx/nas100d-setup.c
5  * NAS 100d board-setup
9  * based on ixdp425-setup.c:
10  *      Copyright (C) 2003-2004 MontaVista Software, Inc.
11  * based on nas100d-power.c:
13  * based on nas100d-io.c
18  * Maintainers: http://www.nslu2-linux.org/
33 #include <asm/mach-types.h>
43 #define NAS100D_PB_GPIO         14   /* power button */
44 #define NAS100D_RB_GPIO         4    /* reset button */
64 	.name			= "IXP4XX-Flash",
101 	.name			= "leds-gpio",
102 	.id			= -1,
107 	.dev_id		= "i2c-gpio.0",
117 	.name			= "i2c-gpio",
167 /* Built-in 10/100 Ethernet MAC interfaces */
209 /* This is used to make sure the power-button pusher is serious.  The button
214 /* Must hold the button down for at least this many counts to be processed */
223 	 * state of the power button.  in nas100d_power_handler()
228 		/* IO Pin is 1 (button pushed) */  in nas100d_power_handler()
230 			power_button_countdown--;  in nas100d_power_handler()
234 		/* Done on button release, to allow for auto-power-on mods. */  in nas100d_power_handler()
254 	/* This is the paper-clip reset, it shuts the machine down directly. */  in nas100d_reset_handler()
266 	 * The power button on the Iomega NAS100d is on GPIO 14, but  in nas100d_gpio_init()
274 	/* Make sure that the power button GPIO is set up as an input */  in nas100d_gpio_init()
275 	gpio_request(NAS100D_PB_GPIO, "power button");  in nas100d_gpio_init()
278 	/* Set the initial value for the power button IRQ handler */  in nas100d_gpio_init()
296 		IXP4XX_EXP_BUS_BASE(0) + ixp4xx_exp_bus_size - 1;  in nas100d_init()
314 		IRQF_TRIGGER_LOW, "NAS100D reset button", NULL) < 0) {  in nas100d_init()
316 		printk(KERN_DEBUG "Reset Button IRQ %d not available\n",  in nas100d_init()
341 	/* Maintainer: www.nslu2-linux.org */