Lines Matching +full:charge +full:- +full:status +full:- +full:gpios
4 * This file is dual-licensed: you can use it either under the terms
21 * b) Permission is hereby granted, free of charge, to any person
43 /dts-v1/;
44 #include "sun8i-h3.dtsi"
45 #include "sunxi-common-regulators.dtsi"
47 #include <dt-bindings/gpio/gpio.h>
48 #include <dt-bindings/input/input.h>
52 compatible = "xunlong,orangepi-2", "allwinner,sun8i-h3";
56 /* ethernet0 is the H3 emac, defined in sun8i-h3.dtsi */
62 stdout-path = "serial0:115200n8";
66 compatible = "hdmi-connector";
71 remote-endpoint = <&hdmi_out_con>;
77 compatible = "gpio-leds";
80 label = "orangepi:red:status";
81 gpios = <&pio 0 15 GPIO_ACTIVE_HIGH>;
86 gpios = <&r_pio 0 10 GPIO_ACTIVE_HIGH>;
87 default-state = "on";
92 compatible = "gpio-keys";
97 gpios = <&r_pio 0 4 GPIO_ACTIVE_LOW>;
103 gpios = <&r_pio 0 3 GPIO_ACTIVE_LOW>;
108 compatible = "mmc-pwrseq-simple";
109 reset-gpios = <&r_pio 0 7 GPIO_ACTIVE_LOW>; /* PL7 WIFI_EN */
114 allwinner,pa-gpios = <&pio 0 16 GPIO_ACTIVE_HIGH>; /* PA16 */
115 allwinner,audio-routing =
119 status = "okay";
123 status = "okay";
127 status = "okay";
131 phy-handle = <&int_mii_phy>;
132 phy-mode = "mii";
133 allwinner,leds-active-low;
134 status = "okay";
138 status = "okay";
143 remote-endpoint = <&hdmi_con_in>;
148 pinctrl-names = "default";
149 pinctrl-0 = <&r_ir_rx_pin>;
150 status = "okay";
154 vmmc-supply = <®_vcc3v3>;
155 bus-width = <4>;
156 cd-gpios = <&pio 5 6 GPIO_ACTIVE_LOW>; /* PF6 */
157 status = "okay";
161 vmmc-supply = <®_vcc3v3>;
162 mmc-pwrseq = <&wifi_pwrseq>;
163 bus-width = <4>;
164 non-removable;
165 status = "okay";
169 * alias for it (which e.g. makes u-boot set a mac-address).
178 status = "okay";
182 pinctrl-names = "default";
183 pinctrl-0 = <&uart0_pa_pins>;
184 status = "okay";
188 pinctrl-names = "default";
189 pinctrl-0 = <&uart1_pins>;
190 status = "disabled";
194 pinctrl-names = "default";
195 pinctrl-0 = <&uart2_pins>;
196 status = "disabled";
200 pinctrl-names = "default";
201 pinctrl-0 = <&uart3_pins>;
202 status = "disabled";
206 usb1_vbus-supply = <®_usb1_vbus>;
207 status = "okay";