Lines Matching +full:sun7i +full:- +full:a20 +full:- +full:codec
4 * This file is dual-licensed: you can use it either under the terms
43 /dts-v1/;
44 #include "sun7i-a20.dtsi"
45 #include "sunxi-common-regulators.dtsi"
46 #include <dt-bindings/gpio/gpio.h>
47 #include <dt-bindings/interrupt-controller/arm-gic.h>
51 compatible = "lemaker,bananapro", "allwinner,sun7i-a20";
60 stdout-path = "serial0:115200n8";
64 compatible = "gpio-leds";
77 wifi_pwrseq: wifi-pwrseq {
78 compatible = "mmc-pwrseq-simple";
79 reset-gpios = <&pio 7 22 GPIO_ACTIVE_LOW>;
82 reg_gmac_3v3: gmac-3v3 {
83 compatible = "regulator-fixed";
84 regulator-name = "gmac-3v3";
85 regulator-min-microvolt = <3300000>;
86 regulator-max-microvolt = <3300000>;
87 startup-delay-us = <100000>;
88 enable-active-high;
97 &codec {
110 pinctrl-names = "default";
111 pinctrl-0 = <&gmac_rgmii_pins>;
112 phy-handle = <&phy1>;
113 phy-mode = "rgmii";
114 phy-supply = <®_gmac_3v3>;
122 compatible = "x-powers,axp209";
124 interrupt-parent = <&nmi_intc>;
127 interrupt-controller;
128 #interrupt-cells = <1>;
137 pinctrl-names = "default";
138 pinctrl-0 = <&ir0_rx_pin>;
143 phy1: ethernet-phy@1 {
149 vmmc-supply = <®_vcc3v3>;
150 bus-width = <4>;
151 cd-gpios = <&pio 7 10 GPIO_ACTIVE_LOW>; /* PH10 */
156 vmmc-supply = <®_vcc3v3>;
157 mmc-pwrseq = <&wifi_pwrseq>;
158 bus-width = <4>;
159 non-removable;
164 compatible = "brcm,bcm4329-fmac";
165 interrupt-parent = <&pio>;
167 interrupt-names = "host-wake";
190 pinctrl-names = "default";
191 pinctrl-0 = <&spi0_pi_pins>,
198 pinctrl-names = "default";
199 pinctrl-0 = <&uart0_pb_pins>;
204 pinctrl-names = "default";
205 pinctrl-0 = <&uart4_ph_pins>;
210 pinctrl-names = "default";
211 pinctrl-0 = <&uart7_pi_pins>;
216 usb1_vbus-supply = <®_usb1_vbus>;
217 usb2_vbus-supply = <®_usb2_vbus>;