Lines Matching +full:charge +full:- +full:status +full:- +full:gpios

5  * This file is dual-licensed: you can use it either under the terms
22  *  b) Permission is hereby granted, free of charge, to any person
44 /dts-v1/;
45 #include "sun4i-a10.dtsi"
46 #include "sunxi-common-regulators.dtsi"
48 #include <dt-bindings/gpio/gpio.h>
52 	compatible = "haoyu,a10-marsboard", "allwinner,sun4i-a10";
59 		stdout-path = "serial0:115200n8";
63 		compatible = "gpio-leds";
67 			gpios = <&pio 1 5 GPIO_ACTIVE_HIGH>;
72 			gpios = <&pio 1 6 GPIO_ACTIVE_HIGH>;
77 			gpios = <&pio 1 7 GPIO_ACTIVE_HIGH>;
82 			gpios = <&pio 1 8 GPIO_ACTIVE_HIGH>;
88 	status = "okay";
92 	status = "okay";
96 	status = "okay";
100 	status = "okay";
104 	status = "okay";
108 	phy-handle = <&phy1>;
109 	status = "okay";
113 	status = "okay";
117 	status = "okay";
121 	status = "okay";
125 	status = "okay";
127 	phy1: ethernet-phy@1 {
133 	vmmc-supply = <&reg_vcc3v3>;
134 	bus-width = <4>;
135 	cd-gpios = <&pio 7 1 GPIO_ACTIVE_LOW>; /* PH1 */
136 	status = "okay";
140 	status = "okay";
144 	status = "okay";
148 	status = "okay";
152 	status = "okay";
156 	status = "okay";
160 	pinctrl-names = "default";
161 	pinctrl-0 = <&spi0_pi_pins>,
163 	status = "okay";
167 	pinctrl-names = "default";
168 	pinctrl-0 = <&uart0_pb_pins>;
169 	status = "okay";
174 	status = "okay";
178 	usb0_id_det-gpios = <&pio 7 4 (GPIO_ACTIVE_HIGH | GPIO_PULL_UP)>; /* PH4 */
179 	usb1_vbus-supply = <&reg_usb1_vbus>;
180 	usb2_vbus-supply = <&reg_usb2_vbus>;
181 	status = "okay";