Lines Matching +full:reset +full:- +full:gpio
1 // SPDX-License-Identifier: GPL-2.0-or-later
3 * Copyright 2012 ST-Ericsson AB
6 #include "ste-href-ab8500.dtsi"
7 #include "ste-href.dtsi"
10 model = "ST-Ericsson HREF (v60+) platform with Device Tree";
11 compatible = "st-ericsson,hrefv60+", "st-ericsson,u8500";
14 /* Name the GPIO muxed rails on the HREF boards */
15 gpio@8012e000 {
16 /* GPIOs 0 - 31 */
17 gpio-line-names =
37 gpio@8012e080 {
38 /* GPIOs 32 - 63 */
39 gpio-line-names =
47 gpio@8000e000 {
48 /* GPIOs 64 - 95 */
49 gpio-line-names = "XENON_EN2 (FLASH_CTRL_4)",
55 /* GPIO 70-77 used for ETM */
57 /* GPIO 78-81 used for YCBCR */
70 gpio@8000e080 {
71 /* GPIOs 96 - 127 */
72 gpio-line-names = "",
80 gpio@8000e100 {
81 /* GPIOs 128 - 159 */
82 gpio-line-names = "", "", "", "", "", "", "", "",
97 gpio@8000e180 {
98 /* GPIOs 160 - 191 */
99 gpio-line-names = "", "", "", "", "", "", "", "",
109 gpio@8011e000 {
110 /* GPIOs 192 - 223 */
111 gpio-line-names = "HDTV_INTN",
117 /* GPIO208-216 used for WGBF_MC1 */
124 gpio@8011e080 {
125 /* GPIOs 224 - 255 */
126 gpio-line-names = "", "",
136 cd-gpios = <&gpio2 31 GPIO_ACTIVE_HIGH>; // 95
139 vmmci: regulator-gpio {
141 enable-gpio = <&gpio5 9 GPIO_ACTIVE_HIGH>;
142 enable-active-high;
150 pinctrl-names = "default";
151 pinctrl-0 = <&ipgpio_hrefv60_mode>,
164 /* SD card detect GPIO pin, extend default state */
169 /* VMMCI level-shifter enable */
174 /* VMMCI level-shifter voltage select */
183 * XENON Flashgun on image processor GPIO (controlled from image
184 * processor firmware), mux in these image processor GPIO lines 0
186 * LED on IP GPIO 4 (XENON_EN2) on altfunction C, that need bias
210 * Drive D19-D23 for the ETM PTM trace interface low,
241 /* NFC ENA and RESET to low, pulldown IRQ line */
278 /* Audio Amplifier HF enable GPIO */
288 * GBF (GPS, Bluetooth, FM-radio) interface,
289 * pull low to reset state
299 /* MSP : HDTV INTERFACE GPIO line */
309 * Display Interface 1 uses GPIO 65 for RST (reset).
310 * Display Interface 2 uses GPIO 66 for RST (reset).
311 * Drive DISP1 reset high (not reset), driver DISP2 reset low (reset)
324 /* Dangling GPIO pins */