Lines Matching +full:headset +full:- +full:detect +full:- +full:gpios
1 // SPDX-License-Identifier: GPL-2.0-only
7 #include "omap4-mcpdm.dtsi"
11 compatible = "gumstix,omap4-duovero", "ti,omap4430", "ti,omap4";
14 stdout-path = &uart3;
23 compatible = "ti,abe-twl6040";
26 ti,mclk-freq = <38400000>;
33 ti,audio-routing =
34 "Headset Stereophone", "HSOL",
35 "Headset Stereophone", "HSOR",
36 "HSMIC", "Headset Mic",
37 "Headset Mic", "Headset Mic Bias";
42 compatible = "usb-nop-xceiv";
43 reset-gpios = <&gpio2 30 GPIO_ACTIVE_LOW>; /* gpio_62 */
44 #phy-cells = <0>;
46 pinctrl-names = "default";
47 pinctrl-0 = <&hsusb1phy_pins>;
50 clock-names = "main_clk";
51 clock-frequency = <19200000>;
56 pinctrl-names = "default";
57 pinctrl-0 = <&w2cbw0015_pins>;
58 compatible = "regulator-fixed";
59 regulator-name = "w2cbw0015";
60 regulator-min-microvolt = <3000000>;
61 regulator-max-microvolt = <3000000>;
63 startup-delay-us = <70000>;
64 enable-active-high;
65 regulator-boot-on;
70 pinctrl-names = "default";
71 pinctrl-0 = <
77 pinctrl-single,pins = <
84 pinctrl-single,pins = <
93 pinctrl-single,pins = <
110 pinctrl-single,pins = <
116 pinctrl-single,pins = <
123 pinctrl-single,pins = <
130 pinctrl-single,pins = <
137 pinctrl-single,pins = <
148 pinctrl-single,pins = <
161 pinctrl-names = "default";
162 pinctrl-0 = <&i2c1_pins>;
164 clock-frequency = <400000>;
173 #clock-cells = <0>;
176 ti,audpwron-gpio = <&gpio6 0 GPIO_ACTIVE_HIGH>; /* gpio_160 */
178 vio-supply = <&v1v8>;
179 v2v1-supply = <&v2v1>;
180 enable-active-high;
187 /* on-board bluetooth / WiFi module */
189 pinctrl-names = "default";
190 pinctrl-0 = <&i2c4_pins>;
192 clock-frequency = <400000>;
196 pinctrl-names = "default";
197 pinctrl-0 = <&mcbsp1_pins>;
202 pinctrl-names = "default";
203 pinctrl-0 = <&mmc1_pins>;
205 vmmc-supply = <&vmmc>;
206 ti,bus-width = <4>;
207 ti,non-removable; /* FIXME: use PMIC_MMC detect */
220 /* on-board WiFi module */
222 pinctrl-names = "default";
223 pinctrl-0 = <&mmc5_pins>;
225 vmmc-supply = <&w2cbw0015_vmmc>;
226 ti,bus-width = <4>;
227 ti,non-removable;
228 cap-power-off-card;
229 keep-power-in-suspend;
233 usb-supply = <&vusb>;
237 interface-type = <1>;
243 port1-mode = "ehci-phy";