Lines Matching +full:touchscreen +full:- +full:min +full:- +full:pressure
1 // SPDX-License-Identifier: GPL-2.0-only
3 #include <dt-bindings/input/input.h>
8 cpu0-supply = <&vcc>;
18 compatible = "regulator-fixed";
19 regulator-name = "vwl1271";
20 regulator-min-microvolt = <1800000>;
21 regulator-max-microvolt = <1800000>;
23 startup-delay-us = <70000>;
24 enable-active-high;
25 vin-supply = <&vaux3>;
30 compatible = "usb-nop-xceiv";
31 reset-gpios = <&gpio1 4 GPIO_ACTIVE_LOW>; /* gpio_4 */
32 #phy-cells = <0>;
37 #clock-cells = <0>;
38 compatible = "fixed-clock";
39 clock-frequency = <26000000>;
47 compatible = "ti,omap2-nand";
49 interrupt-parent = <&gpmc>;
52 linux,mtd-name = "micron,mt29f4g16abbda3w";
53 nand-bus-width = <16>;
54 ti,nand-ecc-opt = "bch8";
55 rb-gpios = <&gpmc 0 GPIO_ACTIVE_HIGH>; /* gpmc_wait0 */
56 gpmc,sync-clk-ps = <0>;
57 gpmc,cs-on-ns = <0>;
58 gpmc,cs-rd-off-ns = <44>;
59 gpmc,cs-wr-off-ns = <44>;
60 gpmc,adv-on-ns = <6>;
61 gpmc,adv-rd-off-ns = <34>;
62 gpmc,adv-wr-off-ns = <44>;
63 gpmc,we-off-ns = <40>;
64 gpmc,oe-off-ns = <54>;
65 gpmc,access-ns = <64>;
66 gpmc,rd-cycle-ns = <82>;
67 gpmc,wr-cycle-ns = <82>;
68 gpmc,wr-access-ns = <40>;
69 gpmc,wr-data-mux-bus-ns = <0>;
70 gpmc,device-width = <2>;
71 #address-cells = <1>;
72 #size-cells = <1>;
77 pinctrl-names = "default";
78 pinctrl-0 = <&i2c1_pins>;
79 clock-frequency = <2600000>;
84 interrupt-parent = <&intc>;
86 clock-names = "fck";
88 compatible = "ti,twl4030-audio";
97 pinctrl-names = "default";
98 pinctrl-0 = <&i2c2_pins>;
99 clock-frequency = <400000>;
103 pinctrl-names = "default";
104 pinctrl-0 = <&i2c3_pins>;
105 clock-frequency = <400000>;
107 touchscreen: tsc2004@48 { label
110 vio-supply = <&vaux1>;
111 pinctrl-names = "default";
112 pinctrl-0 = <&tsc2004_pins>;
113 interrupts-extended = <&gpio5 25 IRQ_TYPE_EDGE_RISING>; /* gpio 153 */
115 touchscreen-fuzz-x = <4>;
116 touchscreen-fuzz-y = <7>;
117 touchscreen-fuzz-pressure = <2>;
118 touchscreen-size-x = <4096>;
119 touchscreen-size-y = <4096>;
120 touchscreen-max-pressure = <2048>;
122 ti,x-plate-ohms = <280>;
123 ti,esd-recovery-timeout-ms = <8000>;
128 interrupts-extended = <&intc 94 &omap3_pmx_core 0x136>;
129 pinctrl-0 = <&mmc3_pins &wl127x_gpio>;
130 pinctrl-names = "default";
131 vmmc-supply = <&wl12xx_vmmc>;
132 non-removable;
133 bus-width = <4>;
134 cap-power-off-card;
135 #address-cells = <1>;
136 #size-cells = <0>;
140 interrupt-parent = <&gpio1>;
142 ref-clock-frequency = <26000000>;
147 port2-mode = "ehci-phy";
156 pinctrl-names = "default";
157 pinctrl-0 = <&hsusb2_pins>;
160 pinctrl-single,pins = <
170 pinctrl-single,pins = <
178 pinctrl-single,pins = <
187 pinctrl-single,pins = <
196 pinctrl-single,pins = <
207 pinctrl-single,pins = <
224 pinctrl-single,pins = <
232 pinctrl-single,pins = <
239 pinctrl-single,pins = <
246 pinctrl-single,pins = <
253 pinctrl-names = "default";
254 pinctrl-0 = <&hsusb2_reset_pin>;
256 pinctrl-single,pins = <
261 pinctrl-single,pins = <
269 pinctrl-names = "default";
270 pinctrl-0 = <&hsusb2_2_pins>;
272 pinctrl-single,pins = <
284 interrupts-extended = <&intc 73 &omap3_pmx_core OMAP3_UART2_RX>;
285 pinctrl-names = "default";
286 pinctrl-0 = <&uart2_pins>;
290 pinctrl-names = "default";
291 pinctrl-0 = <&mcspi1_pins>;
298 regulator-min-microvolt = <2800000>;
299 regulator-max-microvolt = <2800000>;
304 compatible = "ti,twl4030-power-idle-osc-off", "ti,twl4030-power-idle";
310 ti,use-leds;