Lines Matching +full:k2g +full:- +full:dss
1 // SPDX-License-Identifier: GPL-2.0
3 * Device Tree Source for K2G EVM
5 * Copyright (C) 2016-2017 Texas Instruments Incorporated - http://www.ti.com/
7 /dts-v1/;
9 #include "keystone-k2g.dtsi"
12 compatible = "ti,k2g-evm", "ti,k2g", "ti,keystone";
13 model = "Texas Instruments K2G General Purpose EVM";
20 reserved-memory {
21 #address-cells = <2>;
22 #size-cells = <2>;
25 dsp_common_memory: dsp-common-memory@81f800000 {
26 compatible = "shared-dma-pool";
33 vcc3v3_dcin_reg: fixedregulator-vcc3v3-dcin {
34 compatible = "regulator-fixed";
35 regulator-name = "mmc0_fixed";
36 regulator-min-microvolt = <3300000>;
37 regulator-max-microvolt = <3300000>;
38 regulator-always-on;
41 vcc1v8_ldo1_reg: fixedregulator-vcc1v8-ldo1 {
42 compatible = "regulator-fixed";
43 regulator-name = "ldo1";
44 regulator-min-microvolt = <1800000>;
45 regulator-max-microvolt = <1800000>;
46 regulator-always-on;
50 compatible = "hdmi-connector";
57 remote-endpoint = <&sii9022_out>;
65 pinctrl-single,pins = <
72 pinctrl-single,pins = <
84 pinctrl-single,pins = <
99 pinctrl-single,pins = <
106 pinctrl-single,pins = <
113 pinctrl-single,pins = <
119 pinctrl-single,pins = <
128 pinctrl-single,pins = <
140 pinctrl-single,pins = <
147 pinctrl-single,pins = <
154 pinctrl-single,pins = <
161 pinctrl-single,pins = <
178 pinctrl-single,pins = <
185 pinctrl-single,pins = <
220 pinctrl-names = "default";
221 pinctrl-0 = <&uart0_pins>;
230 pinctrl-names = "default";
231 pinctrl-0 = <&mmc0_pins>;
232 vmmc-supply = <&vcc3v3_dcin_reg>;
233 vqmmc-supply = <&vcc3v3_dcin_reg>;
234 cd-gpios = <&gpio1 12 GPIO_ACTIVE_LOW>;
239 pinctrl-names = "default";
240 pinctrl-0 = <&mmc1_pins>;
241 vmmc-supply = <&vcc3v3_dcin_reg>; /* VCC3V3_EMMC is connected to VCC3V3_DCIN */
242 vqmmc-supply = <&vcc1v8_ldo1_reg>;
243 ti,non-removable;
248 memory-region = <&dsp_common_memory>;
253 pinctrl-names = "default";
254 pinctrl-0 = <&i2c0_pins>;
291 pinctrl-names = "default";
292 pinctrl-0 = <&ecap0_pins>;
296 pinctrl-names = "default";
297 pinctrl-0 = <&spi1_pins>;
301 #address-cells = <1>;
302 #size-cells = <1>;
303 compatible = "jedec,spi-nor";
304 spi-max-frequency = <5000000>;
305 m25p,fast-read;
309 label = "u-boot-spl";
311 read-only;
323 pinctrl-names = "default";
324 pinctrl-0 = <&qspi_pins>;
325 cdns,rclk-en;
328 compatible = "s25fl512s", "jedec,spi-nor";
330 spi-tx-bus-width = <1>;
331 spi-rx-bus-width = <4>;
332 spi-max-frequency = <96000000>;
333 #address-cells = <1>;
334 #size-cells = <1>;
335 cdns,read-delay = <5>;
336 cdns,tshsl-ns = <500>;
337 cdns,tsd2d-ns = <500>;
338 cdns,tchsh-ns = <119>;
339 cdns,tslch-ns = <119>;
342 label = "QSPI.u-boot-spl-os";
346 label = "QSPI.u-boot-env";
354 label = "QSPI.pmmc-firmware";
362 label = "QSPI.file-system";
369 pinctrl-names = "default";
370 pinctrl-0 = <&uart2_pins>;
375 pinctrl-names = "default";
376 pinctrl-0 = <&dcan0_pins>;
381 pinctrl-names = "default";
382 pinctrl-0 = <&dcan1_pins>;
395 pinctrl-names = "default";
396 pinctrl-0 = <&mdio_pins>;
398 ethphy0: ethernet-phy@0 {
404 phy-handle = <ðphy0>;
405 phy-mode = "rgmii-rxid";
410 pinctrl-names = "default";
411 pinctrl-0 = <&emac_pins>;
416 pinctrl-names = "default";
417 pinctrl-0 = <&i2c1_pins>;
419 clock-frequency = <400000>;
422 #sound-dai-cells = <0>;
427 #address-cells = <1>;
428 #size-cells = <0>;
434 remote-endpoint = <&dpi_out>;
442 remote-endpoint = <&hdmi_connector_in>;
449 &dss {
450 pinctrl-names = "default";
451 pinctrl-0 = <&vout_pins>;
456 remote-endpoint = <&sii9022_in>;
457 data-lines = <24>;