Lines Matching +full:u +full:- +full:boot +full:- +full:spl
5 * This file is dual-licensed: you can use it either under the terms
38 /dts-v1/;
42 #include <dt-bindings/gpio/gpio.h>
43 #include <dt-bindings/pwm/pwm.h>
44 #include <dt-bindings/sound/fsl-imx-audmux.h>
56 compatible = "pwm-backlight";
57 pinctrl-names = "default";
58 pinctrl-0 = <&pinctrl_backlight>;
60 brightness-levels = < 0 1 2 3 4 5 6 7 8 9
86 default-brightness-level = <250>;
87 enable-gpios = <&gpio5 7 GPIO_ACTIVE_HIGH>;
90 reg_lvds: regulator-lvds {
91 compatible = "regulator-fixed";
92 regulator-name = "lvds_ppen";
93 regulator-min-microvolt = <3300000>;
94 regulator-max-microvolt = <3300000>;
95 regulator-boot-on;
96 regulator-always-on;
97 pinctrl-names = "default";
98 pinctrl-0 = <&pinctrl_reg_lvds>;
100 enable-active-high;
103 reg_usbh1_vbus: usb-h1-vbus {
104 compatible = "regulator-fixed";
106 pinctrl-names = "default";
107 pinctrl-0 = <&pinctrl_usbh1_vbus>;
108 regulator-name = "usb_h1_vbus";
109 regulator-min-microvolt = <5000000>;
110 regulator-max-microvolt = <5000000>;
111 regulator-enable-ramp-delay = <300000>;
115 compatible = "simple-audio-card";
116 label = "tfa9879-mono";
118 simple-audio-card,dai-link {
121 bitclock-master = <&dailink_master>;
122 frame-master = <&dailink_master>;
125 sound-dai = <&ssi2>;
128 sound-dai = <&codec>;
133 panel: panel-lvds0 {
135 power-supply = <®_lvds>;
139 remote-endpoint = <&lvds0_out>;
146 pinctrl-names = "default";
147 pinctrl-0 = <&pinctrl_audmux>;
151 fsl,audmux-port = <1>;
152 fsl,port-config = <
163 fsl,audmux-port = <5>;
164 fsl,port-config = <
179 cs-gpios = <&gpio5 29 GPIO_ACTIVE_LOW>;
180 pinctrl-names = "default";
181 pinctrl-0 = <&pinctrl_ecspi2 &pinctrl_ecspi2_cs &pinctrl_ecspi2_flwp>;
185 #address-cells = <1>;
186 #size-cells = <1>;
187 compatible = "jedec,spi-nor";
188 spi-max-frequency = <40000000>;
192 label = "SPL (spi)";
194 read-only;
197 label = "u-boot (spi)";
199 read-only;
202 label = "uboot-env (spi)";
206 label = "uboot-envr (spi)";
210 label = "linux-recovery (spi)";
214 label = "swupdate-fitImg (spi)";
218 label = "swupdate-initramfs (spi)";
225 cs-gpios = <&gpio4 24 GPIO_ACTIVE_LOW>;
226 pinctrl-names = "default";
227 pinctrl-0 = <&pinctrl_ecspi3 &pinctrl_ecspi3_cs &pinctrl_ecspi3_flwp>;
232 pinctrl-names = "default";
233 pinctrl-0 = <&pinctrl_enet>;
234 phy-handle = <ðernet_phy0>;
235 phy-mode = "rgmii-id";
239 #address-cells = <1>;
240 #size-cells = <0>;
241 ethernet_phy0: ethernet-phy@0 {
243 device_type = "ethernet-phy";
245 /* On - Link, Blink - Activity, Off - No Link */
246 marvell,reg-init = <3 0x10 0 0x1011>;
247 max-speed = <100>;
254 clock-frequency = <400000>;
255 pinctrl-names = "default";
256 pinctrl-0 = <&pinctrl_i2c1>;
260 #sound-dai-cells = <0>;
267 clock-frequency = <400000>;
268 pinctrl-names = "default";
269 pinctrl-0 = <&pinctrl_i2c2>;
274 clock-frequency = <400000>;
275 pinctrl-names = "default";
276 pinctrl-0 = <&pinctrl_i2c3>;
291 regulator-min-microvolt = <300000>;
292 regulator-max-microvolt = <1875000>;
293 regulator-boot-on;
294 regulator-always-on;
295 regulator-ramp-delay = <6250>;
299 regulator-min-microvolt = <300000>;
300 regulator-max-microvolt = <1875000>;
301 regulator-boot-on;
302 regulator-always-on;
303 regulator-ramp-delay = <6250>;
307 regulator-min-microvolt = <800000>;
308 regulator-max-microvolt = <3950000>;
309 regulator-boot-on;
310 regulator-always-on;
314 regulator-min-microvolt = <400000>;
315 regulator-max-microvolt = <1975000>;
316 regulator-boot-on;
317 regulator-always-on;
321 regulator-min-microvolt = <400000>;
322 regulator-max-microvolt = <1975000>;
323 regulator-boot-on;
324 regulator-always-on;
328 regulator-min-microvolt = <800000>;
329 regulator-max-microvolt = <3300000>;
333 regulator-min-microvolt = <5000000>;
334 regulator-max-microvolt = <5150000>;
338 regulator-min-microvolt = <1000000>;
339 regulator-max-microvolt = <3000000>;
340 regulator-boot-on;
341 regulator-always-on;
345 regulator-boot-on;
346 regulator-always-on;
350 regulator-min-microvolt = <800000>;
351 regulator-max-microvolt = <1550000>;
355 regulator-min-microvolt = <800000>;
356 regulator-max-microvolt = <1550000>;
360 regulator-min-microvolt = <1800000>;
361 regulator-max-microvolt = <3300000>;
365 regulator-min-microvolt = <1800000>;
366 regulator-max-microvolt = <3300000>;
367 regulator-always-on;
371 regulator-min-microvolt = <1800000>;
372 regulator-max-microvolt = <3300000>;
373 regulator-always-on;
377 regulator-min-microvolt = <1800000>;
378 regulator-max-microvolt = <3300000>;
379 regulator-always-on;
388 lvds0: lvds-channel@0 {
395 remote-endpoint = <&panel_in_lvds0>;
402 pinctrl-names = "default";
403 pinctrl-0 = <&pinctrl_pwm2>;
412 pinctrl-names = "default";
413 pinctrl-0 = <&pinctrl_uart4>;
414 uart-has-rtscts;
419 pinctrl-names = "default";
420 pinctrl-0 = <&pinctrl_uart5>;
425 vbus-supply = <®_usbh1_vbus>;
426 pinctrl-0 = <&pinctrl_usbh1>;
431 pinctrl-names = "default";
432 pinctrl-0 = <&pinctrl_usdhc4>;
433 bus-width = <8>;
434 non-removable;