Lines Matching +full:imx28 +full:- +full:i2c
1 // SPDX-License-Identifier: GPL-2.0-or-later
3 * Copyright (C) 2013-2014,2016 Michael Heimpold <mhei@heimpold.de>
4 * Copyright (C) 2015-2017 I2SE GmbH <info@i2se.com>
7 /dts-v1/;
8 #include <dt-bindings/gpio/gpio.h>
9 #include "imx28.dtsi"
13 compatible = "i2se,duckbill", "fsl,imx28";
23 compatible = "fsl,imx28-mmc";
24 pinctrl-names = "default";
25 pinctrl-0 = <&mmc0_4bit_pins_a
27 bus-width = <4>;
28 vmmc-supply = <®_3p3v>;
33 compatible = "fsl,imx28-spi";
34 pinctrl-names = "default";
35 pinctrl-0 = <&spi2_pins_a>;
40 pinctrl-names = "default";
41 pinctrl-0 = <&hog_pins_a>;
45 fsl,pinmux-ids = <
48 fsl,drive-strength = <MXS_DRIVE_4mA>;
50 fsl,pull-up = <MXS_PULL_DISABLE>;
53 mac0_phy_reset_pin: mac0-phy-reset@0 {
55 fsl,pinmux-ids = <
58 fsl,drive-strength = <MXS_DRIVE_4mA>;
60 fsl,pull-up = <MXS_PULL_DISABLE>;
65 fsl,pinmux-ids = <
69 fsl,drive-strength = <MXS_DRIVE_4mA>;
71 fsl,pull-up = <MXS_PULL_DISABLE>;
81 i2c0: i2c@80058000 {
82 pinctrl-names = "default";
83 pinctrl-0 = <&i2c0_pins_a>;
88 pinctrl-names = "default";
89 pinctrl-0 = <&auart0_2pins_a>;
94 pinctrl-names = "default";
95 pinctrl-0 = <&duart_pins_a>;
112 phy-mode = "rmii";
113 pinctrl-names = "default";
114 pinctrl-0 = <&mac0_pins_a>, <&mac0_phy_reset_pin>;
115 phy-supply = <®_3p3v>;
116 phy-reset-gpios = <&gpio2 7 GPIO_ACTIVE_LOW>;
117 phy-reset-duration = <25>;
122 reg_3p3v: regulator-3p3v {
123 compatible = "regulator-fixed";
124 regulator-name = "3P3V";
125 regulator-min-microvolt = <3300000>;
126 regulator-max-microvolt = <3300000>;
127 regulator-always-on;
131 compatible = "gpio-leds";
132 pinctrl-names = "default";
133 pinctrl-0 = <&led_pins>;
135 status-red {
138 linux,default-trigger = "default-on";
141 status-green {
144 linux,default-trigger = "heartbeat";