Lines Matching +full:pixelclk +full:- +full:active
1 // SPDX-License-Identifier: GPL-2.0-or-later
8 * The CFA-10057 is an expansion board for the CFA-10036 module, thus we
9 * need to include the CFA-10036 DTS.
11 #include "imx28-cfa10036.dts"
14 model = "Crystalfontz CFA-10057 Board";
20 usb_pins_cfa10057: usb-10057@0 {
22 fsl,pinmux-ids = <
25 fsl,drive-strength = <MXS_DRIVE_4mA>;
27 fsl,pull-up = <MXS_PULL_DISABLE>;
30 lcdif_18bit_pins_cfa10057: lcdif-18bit@0 {
32 fsl,pinmux-ids = <
52 fsl,drive-strength = <MXS_DRIVE_4mA>;
54 fsl,pull-up = <MXS_PULL_DISABLE>;
57 lcdif_pins_cfa10057: lcdif-evk@0 {
59 fsl,pinmux-ids = <
65 fsl,drive-strength = <MXS_DRIVE_4mA>;
67 fsl,pull-up = <MXS_PULL_DISABLE>;
72 pinctrl-names = "default";
73 pinctrl-0 = <&lcdif_18bit_pins_cfa10057
79 bits-per-pixel = <32>;
80 bus-width = <18>;
82 display-timings {
83 native-mode = <&timing0>;
85 clock-frequency = <30000000>;
88 hfront-porch = <12>;
89 hback-porch = <2>;
90 vfront-porch = <5>;
91 vback-porch = <3>;
92 hsync-len = <2>;
93 vsync-len = <2>;
94 hsync-active = <0>;
95 vsync-active = <0>;
96 de-active = <1>;
97 pixelclk-active = <1>;
106 fsl,lradc-touchscreen-wires = <4>;
111 pinctrl-names = "default";
112 pinctrl-0 = <&pwm4_pins_a>;
117 pinctrl-names = "default";
118 pinctrl-0 = <&i2c1_pins_a>;
130 vbus-supply = <®_usb1_vbus>;
131 pinctrl-0 = <&usb1_pins_a>;
132 pinctrl-names = "default";
138 compatible = "simple-bus";
139 #address-cells = <1>;
140 #size-cells = <0>;
143 compatible = "regulator-fixed";
145 pinctrl-names = "default";
146 pinctrl-0 = <&usb_pins_cfa10057>;
147 regulator-name = "usb1_vbus";
148 regulator-min-microvolt = <5000000>;
149 regulator-max-microvolt = <5000000>;
156 phy-mode = "rmii";
157 pinctrl-names = "default";
158 pinctrl-0 = <&mac0_pins_a>;
159 phy-reset-gpios = <&gpio2 21 GPIO_ACTIVE_LOW>;
160 phy-reset-duration = <100>;
166 compatible = "pwm-backlight";
168 brightness-levels = <0 4 8 16 32 64 128 255>;
169 default-brightness-level = <7>;