Lines Matching +full:vdd +full:- +full:micbias +full:- +full:supply
1 // SPDX-License-Identifier: GPL-2.0-only
3 * Copyright (C) 2014 Gumstix, Inc. - https://www.gumstix.com/
5 /dts-v1/;
7 #include <dt-bindings/input/input.h>
12 compatible = "gumstix,am335x-pepper", "ti,am33xx";
16 cpu0-supply = <&dcdc3_reg>;
26 compatible = "gpio-keys";
30 compatible = "gpio-leds";
38 compatible = "ti,da830-evm-audio";
42 compatible = "regulator-fixed";
46 compatible = "regulator-fixed";
50 compatible = "regulator-fixed";
57 pinctrl-names = "default";
58 pinctrl-0 = <&i2c0_pins>;
60 clock-frequency = <400000>;
74 ai3x-micbias-vg = <0x2>;
85 pinctrl-names = "default";
86 pinctrl-0 = <&i2c1_pins>;
87 clock-frequency = <400000>;
92 pinctrl-single,pins = <
98 pinctrl-single,pins = <
107 pinctrl-names = "default";
108 pinctrl-0 = <&accel_pins>;
110 Vdd-supply = <&ldo3_reg>;
111 Vdd_IO-supply = <&ldo3_reg>;
112 st,irq1-click;
113 st,wakeup-x-lo;
114 st,wakeup-x-hi;
115 st,wakeup-y-lo;
116 st,wakeup-y-hi;
117 st,wakeup-z-lo;
118 st,wakeup-z-hi;
119 st,min-limit-x = <92>;
120 st,max-limit-x = <14>;
121 st,min-limit-y = <14>;
122 st,max-limit-y = <92>;
123 st,min-limit-z = <92>;
124 st,max-limit-z = <14>;
129 pinctrl-single,pins = <
139 reset-gpios = <&gpio1 16 GPIO_ACTIVE_LOW>;
140 AVDD-supply = <&ldo3_reg>;
141 IOVDD-supply = <&ldo3_reg>;
142 DRVDD-supply = <&ldo3_reg>;
143 DVDD-supply = <&dcdc1_reg>;
147 ti,model = "AM335x-EVM";
148 ti,audio-codec = <&audio_codec>;
149 ti,mcasp-controller = <&mcasp0>;
150 ti,codec-clock-rate = <12000000>;
151 ti,audio-routing =
159 pinctrl-names = "default";
160 pinctrl-0 = <&audio_pins>;
162 op-mode = <0>; /* MCASP_ISS_MODE */
163 tdm-slots = <2>;
164 serial-dir = <
170 tx-num-evt = <1>;
171 rx-num-evt = <1>;
176 pinctrl-single,pins = <
187 /* Display: 24-bit LCD Screen */
190 pinctrl-names = "default";
191 pinctrl-0 = <&lcd_pins>;
192 panel-info {
193 ac-bias = <255>;
194 ac-bias-intrpt = <0>;
195 dma-burst-sz = <16>;
198 sync-edge = <0>;
199 sync-ctrl = <1>;
200 raster-order = <0>;
201 fifo-th = <0>;
203 display-timings {
204 native-mode = <&timing0>;
206 clock-frequency = <18400000>;
209 hfront-porch = <8>;
210 hback-porch = <4>;
211 hsync-len = <41>;
212 vfront-porch = <4>;
213 vback-porch = <2>;
214 vsync-len = <10>;
215 hsync-active = <1>;
216 vsync-active = <1>;
227 pinctrl-single,pins = <
265 phy-handle = <ðphy0>;
266 phy-mode = "rgmii";
271 phy-handle = <ðphy1>;
272 phy-mode = "rgmii";
277 pinctrl-names = "default";
278 pinctrl-0 = <&mdio_pins>;
280 ethphy0: ethernet-phy@0 {
284 ethphy1: ethernet-phy@1 {
291 pinctrl-names = "default";
292 pinctrl-0 = <ðernet_pins>;
298 pinctrl-single,pins = <
319 pinctrl-single,pins = <
330 vmmc-supply = <&ldo3_reg>;
331 bus-width = <4>;
332 pinctrl-names = "default";
333 pinctrl-0 = <&sd_pins>;
334 cd-gpios = <&gpio0 6 GPIO_ACTIVE_LOW>;
340 pinctrl-names = "default";
341 pinctrl-0 = <&emmc_pins>;
342 vmmc-supply = <&ldo3_reg>;
343 bus-width = <8>;
344 non-removable;
350 pinctrl-names = "default";
351 pinctrl-0 = <&wireless_pins>;
352 vmmmc-supply = <&v3v3c_reg>;
353 bus-width = <4>;
354 non-removable;
357 dma-names = "tx", "rx";
363 pinctrl-single,pins = <
374 pinctrl-single,pins = <
390 pinctrl-single,pins = <
409 regulator-name = "vbat";
410 regulator-min-microvolt = <5000000>;
411 regulator-max-microvolt = <5000000>;
415 regulator-name = "v3v3c_reg";
416 regulator-min-microvolt = <3300000>;
417 regulator-max-microvolt = <3300000>;
418 vin-supply = <&vbat>;
422 regulator-name = "vdd5_reg";
423 regulator-min-microvolt = <5000000>;
424 regulator-max-microvolt = <5000000>;
425 vin-supply = <&vbat>;
434 default-brightness = <80>;
439 /* VDD_1V8 system supply */
440 regulator-always-on;
444 /* VDD_CORE voltage limits 0.95V - 1.26V with +/-4% tolerance */
445 regulator-name = "vdd_core";
446 regulator-min-microvolt = <925000>;
447 regulator-max-microvolt = <1150000>;
448 regulator-boot-on;
449 regulator-always-on;
453 /* VDD_MPU voltage limits 0.95V - 1.1V with +/-4% tolerance */
454 regulator-name = "vdd_mpu";
455 regulator-min-microvolt = <925000>;
456 regulator-max-microvolt = <1325000>;
457 regulator-boot-on;
458 regulator-always-on;
462 /* VRTC 1.8V always-on supply */
463 regulator-name = "vrtc,vdds";
464 regulator-always-on;
469 regulator-name = "vdd_3v3aux";
470 regulator-always-on;
475 regulator-name = "vdd_3v3a";
476 regulator-min-microvolt = <3300000>;
477 regulator-max-microvolt = <3300000>;
482 regulator-name = "vdd_3v3b";
483 regulator-always-on;
491 pinctrl-names = "default";
492 pinctrl-0 = <&spi0_pins>;
497 pinctrl-single,pins = <
511 ti,x-plate-resistance = <200>;
512 ti,coordinate-readouts = <5>;
513 ti,wire-config = <0x00 0x11 0x22 0x33>;
517 ti,adc-channels = <4 5 6 7>;
525 pinctrl-names = "default";
526 pinctrl-0 = <&uart0_pins>;
532 pinctrl-names = "default";
533 pinctrl-0 = <&uart1_pins>;
538 pinctrl-single,pins = <
544 pinctrl-single,pins = <
555 pinctrl-names = "default";
556 pinctrl-0 = <&usb_pins>;
569 pinctrl-single,pins = <
570 /* USB0 Over-Current (active low) */
572 /* USB1 Over-Current (active low) */
580 pinctrl-names = "default";
581 pinctrl-0 = <&user_leds_pins>;
586 linux,default-trigger = "none";
587 default-state = "off";
593 linux,default-trigger = "none";
594 default-state = "off";
599 pinctrl-names = "default";
600 pinctrl-0 = <&user_buttons_pins>;
601 #address-cells = <1>;
602 #size-cells = <0>;
608 wakeup-source;
615 wakeup-source;
622 wakeup-source;
628 pinctrl-single,pins = <
635 pinctrl-single,pins = <