Lines Matching +full:u +full:- +full:boot +full:- +full:spl
1 // SPDX-License-Identifier: GPL-2.0-only
3 * Copyright (C) 2012 Texas Instruments Incorporated - https://www.ti.com/
5 /dts-v1/;
8 #include <dt-bindings/interrupt-controller/irq.h>
12 compatible = "ti,am335x-evm", "ti,am33xx";
16 cpu0-supply = <&vdd1_reg>;
26 stdout-path = &uart0;
30 compatible = "regulator-fixed";
31 regulator-name = "vbat";
32 regulator-min-microvolt = <5000000>;
33 regulator-max-microvolt = <5000000>;
34 regulator-boot-on;
38 compatible = "regulator-fixed";
39 regulator-name = "lis3_reg";
40 regulator-boot-on;
44 compatible = "regulator-fixed";
45 regulator-name = "wlan-en-regulator";
46 regulator-min-microvolt = <1800000>;
47 regulator-max-microvolt = <1800000>;
49 /* WLAN_EN GPIO for this board - Bank1, pin16 */
53 startup-delay-us = <70000>;
54 enable-active-high;
58 v1_8d_reg: fixedregulator-v1_8d {
59 compatible = "regulator-fixed";
60 regulator-name = "v1_8d";
61 vin-supply = <&vbat>;
62 regulator-min-microvolt = <1800000>;
63 regulator-max-microvolt = <1800000>;
67 v3_3d_reg: fixedregulator-v3_3d {
68 compatible = "regulator-fixed";
69 regulator-name = "v3_3d";
70 vin-supply = <&vbat>;
71 regulator-min-microvolt = <3300000>;
72 regulator-max-microvolt = <3300000>;
76 compatible = "gpio-matrix-keypad";
77 debounce-delay-ms = <5>;
78 col-scan-delay-us = <2>;
80 row-gpios = <&gpio1 25 GPIO_ACTIVE_HIGH /* Bank1, pin25 */
84 col-gpios = <&gpio1 21 GPIO_ACTIVE_HIGH /* Bank1, pin21 */
96 compatible = "gpio-keys";
97 #address-cells = <1>;
98 #size-cells = <0>;
102 label = "volume-up";
105 wakeup-source;
109 label = "volume-down";
112 wakeup-source;
117 compatible = "pwm-backlight";
119 brightness-levels = <0 51 53 56 62 75 101 152 255>;
120 default-brightness-level = <8>;
124 compatible = "tfc,s9700rtwv43tr-01b";
126 pinctrl-names = "default";
127 pinctrl-0 = <&lcd_pins_s0>;
132 remote-endpoint = <&lcdc_0>;
138 compatible = "simple-audio-card";
139 simple-audio-card,name = "AM335x-EVM";
140 simple-audio-card,widgets =
143 simple-audio-card,routing =
148 simple-audio-card,format = "dsp_b";
149 simple-audio-card,bitclock-master = <&sound_master>;
150 simple-audio-card,frame-master = <&sound_master>;
151 simple-audio-card,bitclock-inversion;
153 simple-audio-card,cpu {
154 sound-dai = <&mcasp1>;
157 sound_master: simple-audio-card,codec {
158 sound-dai = <&tlv320aic3106>;
159 system-clock-frequency = <12000000>;
165 pinctrl-names = "default";
166 pinctrl-0 = <&matrix_keypad_s0 &volume_keys_s0 &clkout2_pin>;
169 pinctrl-single,pins = <
179 pinctrl-single,pins = <
186 pinctrl-single,pins = <
193 pinctrl-single,pins = <
200 pinctrl-single,pins = <
207 pinctrl-single,pins = <
216 pinctrl-single,pins = <
222 pinctrl-single,pins = <
242 pinctrl-single,pins = <
248 pinctrl-single,pins = <
266 pinctrl-single,pins = <
284 pinctrl-single,pins = <
292 pinctrl-single,pins = <
300 pinctrl-single,pins = <
313 pinctrl-single,pins = <
324 pinctrl-single,pins = <
332 pinctrl-single,pins = <
365 pinctrl-single,pins = <
374 pinctrl-single,pins = <
383 pinctrl-single,pins = <
391 pinctrl-names = "default";
392 pinctrl-0 = <&uart0_pins>;
398 pinctrl-names = "default";
399 pinctrl-0 = <&uart1_pins>;
405 pinctrl-names = "default";
406 pinctrl-0 = <&i2c0_pins>;
409 clock-frequency = <400000>;
421 pinctrl-names = "default";
422 pinctrl-0 = <&i2c1_pins>;
425 clock-frequency = <100000>;
430 Vdd-supply = <&lis3_reg>;
431 Vdd_IO-supply = <&lis3_reg>;
433 st,click-single-x;
434 st,click-single-y;
435 st,click-single-z;
436 st,click-thresh-x = <10>;
437 st,click-thresh-y = <10>;
438 st,click-thresh-z = <10>;
439 st,irq1-click;
440 st,irq2-click;
441 st,wakeup-x-lo;
442 st,wakeup-x-hi;
443 st,wakeup-y-lo;
444 st,wakeup-y-hi;
445 st,wakeup-z-lo;
446 st,wakeup-z-hi;
447 st,min-limit-x = <120>;
448 st,min-limit-y = <120>;
449 st,min-limit-z = <140>;
450 st,max-limit-x = <550>;
451 st,max-limit-y = <550>;
452 st,max-limit-z = <750>;
466 #sound-dai-cells = <0>;
472 AVDD-supply = <&v3_3d_reg>;
473 IOVDD-supply = <&v3_3d_reg>;
474 DRVDD-supply = <&v3_3d_reg>;
475 DVDD-supply = <&v1_8d_reg>;
482 blue-and-red-wiring = "crossed";
486 remote-endpoint = <&panel_0>;
500 pinctrl-names = "default";
501 pinctrl-0 = <&ecap0_pins>;
507 pinctrl-names = "default";
508 pinctrl-0 = <&nandflash_pins_s0>;
511 compatible = "ti,omap2-nand";
513 interrupt-parent = <&gpmc>;
516 rb-gpios = <&gpmc 0 GPIO_ACTIVE_HIGH>; /* gpmc_wait0 */
517 ti,nand-xfer-type = "prefetch-dma";
518 ti,nand-ecc-opt = "bch8";
519 ti,elm-id = <&elm>;
520 nand-bus-width = <8>;
521 gpmc,device-width = <1>;
522 gpmc,sync-clk-ps = <0>;
523 gpmc,cs-on-ns = <0>;
524 gpmc,cs-rd-off-ns = <44>;
525 gpmc,cs-wr-off-ns = <44>;
526 gpmc,adv-on-ns = <6>;
527 gpmc,adv-rd-off-ns = <34>;
528 gpmc,adv-wr-off-ns = <44>;
529 gpmc,we-on-ns = <0>;
530 gpmc,we-off-ns = <40>;
531 gpmc,oe-on-ns = <0>;
532 gpmc,oe-off-ns = <54>;
533 gpmc,access-ns = <64>;
534 gpmc,rd-cycle-ns = <82>;
535 gpmc,wr-cycle-ns = <82>;
536 gpmc,bus-turnaround-ns = <0>;
537 gpmc,cycle2cycle-delay-ns = <0>;
538 gpmc,clk-activation-ns = <0>;
539 gpmc,wr-access-ns = <40>;
540 gpmc,wr-data-mux-bus-ns = <0>;
542 /* All SPL-* partitions are sized to minimal length
544 * NAND flash this is equal to size of erase-block */
545 #address-cells = <1>;
546 #size-cells = <1>;
548 label = "NAND.SPL";
552 label = "NAND.SPL.backup1";
556 label = "NAND.SPL.backup2";
560 label = "NAND.SPL.backup3";
564 label = "NAND.u-boot-spl-os";
568 label = "NAND.u-boot";
572 label = "NAND.u-boot-env";
576 label = "NAND.u-boot-env.backup1";
584 label = "NAND.file-system";
593 #sound-dai-cells = <0>;
594 pinctrl-names = "default", "sleep";
595 pinctrl-0 = <&mcasp1_pins>;
596 pinctrl-1 = <&mcasp1_pins_sleep>;
600 op-mode = <0>; /* MCASP_IIS_MODE */
601 tdm-slots = <2>;
603 serial-dir = < /* 0: INACTIVE, 1: TX, 2: RX */
606 tx-num-evt = <32>;
607 rx-num-evt = <32>;
611 vcc1-supply = <&vbat>;
612 vcc2-supply = <&vbat>;
613 vcc3-supply = <&vbat>;
614 vcc4-supply = <&vbat>;
615 vcc5-supply = <&vbat>;
616 vcc6-supply = <&vbat>;
617 vcc7-supply = <&vbat>;
618 vccio-supply = <&vbat>;
622 regulator-always-on;
626 regulator-always-on;
630 /* VDD_MPU voltage limits 0.95V - 1.26V with +/-4% tolerance */
631 regulator-name = "vdd_mpu";
632 regulator-min-microvolt = <912500>;
633 regulator-max-microvolt = <1351500>;
634 regulator-boot-on;
635 regulator-always-on;
639 /* VDD_CORE voltage limits 0.95V - 1.1V with +/-4% tolerance */
640 regulator-name = "vdd_core";
641 regulator-min-microvolt = <912500>;
642 regulator-max-microvolt = <1150000>;
643 regulator-boot-on;
644 regulator-always-on;
648 regulator-always-on;
652 regulator-always-on;
656 regulator-always-on;
660 regulator-always-on;
664 regulator-always-on;
668 regulator-always-on;
672 regulator-always-on;
676 regulator-always-on;
680 regulator-min-microvolt = <1800000>;
681 regulator-max-microvolt = <3300000>;
682 regulator-always-on;
688 pinctrl-names = "default", "sleep";
689 pinctrl-0 = <&cpsw_default>;
690 pinctrl-1 = <&cpsw_sleep>;
696 pinctrl-names = "default", "sleep";
697 pinctrl-0 = <&davinci_mdio_default>;
698 pinctrl-1 = <&davinci_mdio_sleep>;
701 ethphy0: ethernet-phy@0 {
707 phy-handle = <ðphy0>;
708 phy-mode = "rgmii-id";
715 ti,x-plate-resistance = <200>;
716 ti,coordinate-readouts = <5>;
717 ti,wire-config = <0x00 0x11 0x22 0x33>;
718 ti,charge-delay = <0x400>;
722 ti,adc-channels = <4 5 6 7>;
728 vmmc-supply = <&vmmc_reg>;
729 bus-width = <4>;
730 pinctrl-names = "default";
731 pinctrl-0 = <&mmc1_pins>;
732 cd-gpios = <&gpio0 6 GPIO_ACTIVE_LOW>;
737 xbar-event-map element */
740 dma-names = "tx", "rx";
742 vmmc-supply = <&wlan_en_reg>;
743 bus-width = <4>;
744 pinctrl-names = "default";
745 pinctrl-0 = <&mmc3_pins &wlan_pins>;
746 non-removable;
747 cap-power-off-card;
748 keep-power-in-suspend;
750 #address-cells = <1>;
751 #size-cells = <0>;
755 interrupt-parent = <&gpio3>;
770 pinctrl-names = "default";
771 pinctrl-0 = <&dcan1_pins_default>;
776 clock-names = "ext-clk", "int-clk";