Lines Matching full:debug

8 USB2 Debug port key and a debug cable, on x86 systems.
10 You need two computers, the 'USB debug key' special gadget and
13   [host/target] <-------> [USB debug key] <-------> [client/console]
18   a) Host/target system needs to have USB debug port capability.
20      You can check this capability by looking at a 'Debug port' bit in
35                Capabilities: [58] Debug port: BAR=1 offset=00a0
42        If your system does not list a debug port capability then you probably
43        won't be able to use the USB debug key.
45   b) You also need a NetChip USB debug cable/key:
55      debug port on the "host/target" system. You cannot use a USB hub in
56      between the physical debug port and the "host/target" system.
58      The EHCI debug controller is bound to a specific physical USB
61      wired such that the EHCI debug controller is hooked up to the
69      Some hardware vendors do not expose the usb debug port with a
100     On systems with more than one EHCI debug controller you must
101     specify the correct EHCI debug controller number.  The ordering
103     default with no number argument is "0" or the first EHCI debug
104     controller.  To use the second EHCI debug controller, you would
128      and find out which port has a debug device connected.