Lines Matching refs:LED
13 The interface can support both LED and xenon flash devices. As of
23 Unsynchronised LED flash (software strobe)
26 Unsynchronised LED flash is controlled directly by the host as the
34 Synchronised LED flash (hardware strobe)
37 The synchronised LED flash is pre-programmed by the host (power and
45 LED flash as torch
48 LED flash may be used as torch in conjunction with another use case
61 Defines the mode of the flash LED, the high-power white LED attached
81 Defines the source of the flash LED strobe.
118 Intensity of the flash strobe when the flash LED is in flash mode
123 Intensity of the flash LED in torch mode
129 Intensity of the indicator LED. The indicator LED may be fully
130 independent of the flash LED. The unit should be microamps (uA) if
138 if the fault affects the flash LED. Exactly which faults have such
149 - Flash controller voltage to the flash LED has exceeded the limit
161 - Current in the LED power supply has exceeded the limit specific to
165 condition on the indicator LED.
167 - Flash controller voltage to the flash LED has been below the
174 - The temperature of the LED has exceeded its allowed upper limit.
183 charged before strobing. LED flashes often require a cooldown period