Lines Matching full:receiver

199     as soon as the receiver NACKs a byte the transmit will stop, but the
205     This setting can be used to test how well a receiver deals with
211     without ever sending an EOM. This can be used to test how a receiver
218     and not for the final byte. The receiver should ignore the last byte in
220     same reason the whole message is typically ignored. The receiver should be
230     This command can be used to test buffer overflows in the receiver. E.g.
236     two bytes long. The receiver should ignore messages that are too short.
245     than is allowed and the receiver should respond with a Low Drive
249     because the receiver also looks for an Arbitration Lost condition in
262     a receiver will do. It might just accept it, or it might time out and
267     because the receiver also looks for an Arbitration Lost condition in
276     allowed and the receiver should return to Idle state when this is detected.
283     valid and the receiver should return to Idle state when this is detected.
286     what a receiver will do. It might just accept it, or it might time out and
293     hasn't been received yet. This command can be used to test how the receiver
301     receiver handles Low Drive conditions. Note that if this happens at bit
302     positions 0-3 the receiver can interpret this as an Arbitration Lost