Lines Matching full:swap
2 Using swap files with software suspend (swsusp)
7 The Linux kernel handles swap files almost in the same way as it handles swap
8 partitions and there are only two differences between these two types of swap
10 (1) swap files need not be contiguous,
11 (2) the header of a swap file is not in the first block of the partition that
13 already taken care of by the swap-handling code, but (2) has to be taken into
16 In principle the location of a swap file's header may be determined with the
18 filesystem holding the swap file to be mounted, and if this filesystem is
20 identify a swap file swsusp uses the name of the partition that holds the file
21 and the offset from the beginning of the partition at which the swap file's
25 In order to use a swap file with swsusp, you need to:
27 1) Create the swap file and make it active, eg.::
33 2) Use an application that will bmap the swap file with the help of the
34 FIBMAP ioctl and determine the location of the file's swap header, as the
36 holds the swap file.
42 where <swap_file_partition> is the partition on which the swap file is located
43 and <swap_file_offset> is the offset of the swap header determined by the
45 by the same application that determines the swap file's header offset using the
53 to a swap file allowing the resume to be initiated from an initrd or initramfs
56 Now, swsusp will use the swap file in the same way in which it would use a swap
57 partition. In particular, the swap file has to be active (ie. be present in
60 Note that if the swap file used for suspending is deleted and recreated,