Lines Matching full:eth1
1215 must correspond with the name of the file, i.e., ifcfg-eth1 must have
1216 a device line of DEVICE=eth1. The setting of the MASTER= line will
1318 devices (presumed to be eth0 and eth1), and have it persist across
1326 ip link set eth1 master bond0
1548 and eth1), and have it persist across reboots, edit the appropriate
1558 echo +eth1 > /sys/class/net/bond0/bonding/slaves
1592 active-backup mode, with eth0 and eth1 as slaves::
1596 bond-slaves eth0 eth1
1599 bond-primary eth0 eth1
1615 bond-primary eth0 eth1
1617 auto eth1
1618 iface eth1 inet manual
1620 bond-primary eth0 eth1
1635 bonded interface in which eth0 connects to a private network, while eth1
1637 traffic over eth0 first, using eth1 only as a fall back, while all other traffic
1664 Slave Interface: eth1
1672 # echo "eth1:2" > /sys/class/net/bond0/bonding/queue_id
1682 force all traffic bound to 192.168.1.100 to use eth1 in the bond as its output
1694 selection policy to be overridden, selecting instead qid 2, which maps to eth1.
1776 Slave Interface: eth1
1796 (MASTER) while eth0 and eth1 are slaves (SLAVE). Notice all slaves of
1815 eth1 Link encap:Ethernet HWaddr 00:C0:F0:1F:37:B4
1993 device bond0 has two slaves, eth0 and eth1, and the routing table is
1999 10.0.0.0 0.0.0.0 255.255.0.0 U 40 0 0 eth1
2006 case, another host on network 10 would use eth0 or eth1 before bond0).
2036 alias eth1 tg3
2040 If neither eth0 and eth1 are slaves to bond0, then when the
2044 when the e1000 driver loads, it will receive eth0 and eth1 for its
2102 eth1 are slaves of bond0 and the driver for eth0 is loaded before the
2112 interfaces.ifTable.ifEntry.ifDescr.3 = eth1
2129 interfaces.ifTable.ifEntry.ifDescr.4 = eth1
2213 eth0 +-------+ eth1
2298 | |eth1 port2| | here somewhere
2325 | |eth1 port2| +------------------+ Host C |
2652 I/O Module #1; similarly, all eth1 ports are wired to I/O Module #2.
2676 modules 1 and 2. In this configuration, the eth0 and eth1 ports of a
2682 switch. By using PMs in I/O module #1 and #2, the eth0 and eth1