Lines Matching +full:pwm +full:- +full:outputs
10 Addresses scanned: I2C 0x2c - 0x2f
19 -----------------
35 -----------
42 parameter; this will put it into a more well-behaved state first.
48 The driver also implements up to seven fan control outputs: pwm1-7. Pwm1-7
49 can be configured to PWM output or Analogue DC output via their associated
50 pwmX_mode. Outputs pwm4 through pwm7 may or may not be present depending on
53 Automatic fan control mode is possible only for fan1-fan3.
55 For all pwmX outputs, a value of 0 means minimum fan speed and a value of
116 ----------------
118 - This driver is only for Winbond W83792D C version device, there
120 calculation method to in6-in7(measured value, limits) is a little
123 - The function of vid and vrm has not been finished, because I'm NOT
125 - The function of chassis open detection needs more tests.
126 - If you have ASUS server board and chip was not found: Then you will
131 -----------
134 -----------
136 Works as expected. You just need to specify desired PWM/DC value (fan speed)
137 in appropriate pwm# file.
140 --------------
145 via thermal_cruise# file. The tolerance# file serves to create T +- tolerance
147 remains below the thermal_cruise# +- tolerance# value. Once the temperature
149 specific speed set by pwm# and automatically controlled its PWM duty cycle
152 (1) If the temperature still exceeds the high limit, PWM duty
156 limit (T-tolerance), the fan speed will be fixed at the current speed because
159 (3) If the temperature goes below the low limit, PWM duty cycle will decrease
164 ------------
168 temperature region (sf2_point@_fan# +- tolerance#) it will cause fans to run
174 ----------
176 pwm[1-7]
177 - this file stores PWM duty cycle or DC value (fan speed) in range:
180 pwm[1-3]_enable
181 - this file controls mode of fan/temperature control:
187 pwm[1-7]_mode
188 - Select PWM or DC mode
191 * 1 PWM
192 thermal_cruise[1-3]
193 - Selects the desired temperature for cruise (degC)
194 tolerance[1-3]
195 - Value in degrees of Celsius (degC) for +- T
196 sf2_point[1-4]_fan[1-3]
197 - four temperature points for each fan for Smart Fan II
198 sf2_level[1-3]_fan[1-3]
199 - three PWM/DC levels for each fan for Smart Fan II