Lines Matching +full:low +full:- +full:power

10     Addresses scanned: -
14  http://archive.ericsson.net/service/internet/picov/get?DocNo=28701-EN/LZT146395
20     Addresses scanned: -
24 	https://www.onsemi.com/pub_link/Collateral/ADP4000-D.PDF
26 	https://www.onsemi.com/pub_link/Collateral/NCP4200-D.PDF
28 	https://www.onsemi.com/pub_link/Collateral/JUNE%202009-%20REV.%200.PDF
30   * Lineage Power
34     Addresses scanned: -
52     Addresses scanned: -
70     Addresses scanned: -
80     Addresses scanned: -
85 Author: Guenter Roeck <linux@roeck-us.net>
89 -----------
92 It supports voltage, current, power, and temperature sensors as supported
95 Each monitored channel has its own high and low limits, plus a critical
102 -----------
113 	$ echo ltc2978 0x60 > /sys/bus/i2c/devices/i2c-1/new_device
117 ---------------------
121 Emerson DS1200 power modules might look as follows::
185 -------------
193 The following attributes are supported. Limits are read-write; all other
194 attributes are read-only.
206 inX_min_alarm		Voltage low alarm. From VOLTAGE_UV_WARNING status.
208 inX_lcrit_alarm		Voltage critical low alarm.
229 currX_lcrit_alarm	Output current critical low alarm.
239 powerX_input		Measured power. From READ_PIN or READ_POUT register.
240 powerX_cap		Output power cap. From POUT_MAX register.
241 powerX_max		Power limit. From PIN_OP_WARN_LIMIT or
243 powerX_crit		Critical output power limit.
245 powerX_alarm		Power high alarm.
247 powerX_crit_alarm	Output power critical high alarm.
252 powerX_rated_max	Maximum rated power.
259 tempX_lcrit		Critical low temperature.
263 tempX_min_alarm		Chip temperature low alarm. Set by comparing
269 tempX_lcrit_alarm	Chip temperature critical low alarm. Set by comparing