Lines Matching +full:sense +full:- +full:mode
6 - compatible: Should be "marvell,pxa-ohci" for USB controllers
7 used in host mode.
10 - "marvell,enable-port1", "marvell,enable-port2", "marvell,enable-port3"
12 - "marvell,port-mode" selects the mode of the ports:
16 - "marvell,power-sense-low" - power sense pin is low-active.
17 - "marvell,power-control-low" - power control pin is low-active.
18 - "marvell,no-oc-protection" - disable over-current protection.
19 - "marvell,oc-mode-perport" - enable per-port over-current protection.
20 - "marvell,power_on_delay" Power On to Power Good time - in ms.
25 compatible = "marvell,pxa-ohci", "usb-ohci";
28 marvell,enable-port1;
29 marvell,port-mode = <2>; /* PMM_GLOBAL_MODE */
35 - compatible: Should be "marvell,pxa270-udc" for USB controllers
36 used in device mode.
37 - reg: usb device MMIO address space
38 - interrupts: single interrupt generated by the UDC IP
39 - clocks: input clock of the UDC IP (see clock-bindings.txt)
42 - gpios:
43 - gpio activated to control the USB D+ pullup (see gpio.txt)
48 compatible = "marvell,pxa270-udc";