Lines Matching +full:data +full:- +full:role

4  - maximum-speed: tells USB controllers we want to work up to a certain
5 			speed. Valid arguments are "super-speed-plus",
6 			"super-speed", "high-speed", "full-speed" and
7 			"low-speed". In case this isn't passed via DT, USB
10  - dr_mode: tells Dual-Role USB controllers that we want to work on a
15  - phy_type: tells USB controllers that we want to configure the core to support
16 			a UTMI+ PHY with an 8- or 16-bit interface if UTMI+ is
20  - otg-rev: tells usb driver the release number of the OTG and EH supplement
22 			in binary-coded decimal (i.e. 2.0 is 0200H). This
24 			is enabled, if ADP is required, otg-rev should be
26  - companion: phandle of a companion
27  - hnp-disable: tells OTG controllers we want to disable OTG HNP, normally HNP
29 			to be a srp-capable only B device.
30  - srp-disable: tells OTG controllers we want to disable OTG SRP, SRP is
32  - adp-disable: tells OTG controllers we want to disable OTG ADP, ADP is
34  - usb-role-switch: boolean, indicates that the device is capable of assigning
35 			the USB data role (USB host or USB device) for a given
36 			USB connector, such as Type-C, Type-B(micro).
37 			see connector/usb-connector.yaml.
38  - role-switch-default-mode: indicating if usb-role-switch is enabled, the
40 			role is USB_ROLE_NONE. Valid arguments are "host" and
51 	usb-phy = <&usb2_phy>, <&usb3,phy>;
52 	maximum-speed = "super-speed";
55 	otg-rev = <0x0200>;
56 	adp-disable;