Lines Matching +full:8 +full:- +full:channel

7   - compatible: "st,sta32x"
8   - reg: the I2C address of the device for I2C
9   - reset-gpios: a GPIO spec for the reset pin. If specified, it will be
12   - power-down-gpios: a GPIO spec for the power down pin. If specified,
16   - Vdda-supply: regulator spec, providing 3.3V
17   - Vdd3-supply: regulator spec, providing 3.3V
18   - Vcc-supply: regulator spec, providing 5V - 26V
22   - clocks, clock-names: Clock specifier for XTI input clock.
24 	and disabled when it is removed. The 'clock-names' must be set to 'xti'.
26   -  st,output-conf: number, Selects the output configuration:
27 	0: 2-channel (full-bridge) power, 2-channel data-out
28 	1: 2 (half-bridge). 1 (full-bridge) on-board power
29 	2: 2 Channel (Full-Bridge) Power, 1 Channel FFX
30 	3: 1 Channel Mono-Parallel
32 	This property has to be specified as '/bits/ 8' value.
34   -  st,ch1-output-mapping: Channel 1 output mapping
35   -  st,ch2-output-mapping: Channel 2 output mapping
36   -  st,ch3-output-mapping: Channel 3 output mapping
37 	0: Channel 1
38 	1: Channel 2
39 	2: Channel 3
40 	If parameter is missing, channel 1 is chosen.
41 	This properties have to be specified as '/bits/ 8' values.
43   -  st,thermal-warning-recover:
46   - st,fault-detect-recovery:
49   -  st,thermal-warning-adjustment:
52   -  st,fault-detect-recovery:
55   -  st,drop-compensation-ns: number
56 	Only required for "st,ffx-power-output-mode" ==
57 	"variable-drop-compensation".
62   -  st,max-power-use-mpcc:
66   -  st,max-power-corr:
70   -  st,am-reduction-mode:
74   -  st,odd-pwm-speed-mode:
78   -  st,invalid-input-detect-mute:
87 	clock-names = "xti";
88 	reset-gpios = <&gpio1 19 0>;
89 	power-down-gpios = <&gpio1 16 0>;
90 	st,output-conf = /bits/ 8  <0x3>;	// set output to 2-channel
91 						// (full-bridge) power,
92 						// 2-channel data-out
93 	st,ch1-output-mapping = /bits/ 8 <0>;	// set channel 1 output ch 1
94 	st,ch2-output-mapping = /bits/ 8 <0>;	// set channel 2 output ch 1
95 	st,ch3-output-mapping = /bits/ 8 <0>;	// set channel 3 output ch 1
96 	st,max-power-correction;		// enables power bridge
99 	st,invalid-input-detect-mute;		// mute if no valid digital