Lines Matching +full:enable +full:- +full:gpios

4 - compatible: "ti,tps65132"
5 - reg: I2C slave address
9    device node describe the properties of these regulators. The sub-node
11 	-For regulator outp, the sub node name should be "outp".
12 	-For regulator outn, the sub node name should be "outn".
14 -enable-gpios:(active high, output) Regulators are controlled by the input pins.
17 -active-discharge-gpios: (active high, output) Some configurations use delay mechanisms
18   on the enable pin, to keep the regulator enabled for some time after
19   the enable signal goes low. This GPIO is used to actively discharge
20   the delay mechanism. Requires specification of ti,active-discharge-time-us
21 -ti,active-discharge-time-us: how long the active discharge gpio should be
33 			regulator-name = "outp";
34 			regulator-boot-on;
35 			regulator-always-on;
36 			enable-gpios = <&gpio 23 0>;
40 			regulator-name = "outn";
41 			regulator-boot-on;
42 			regulator-always-on;
43 			regulator-active-discharge = <0>;
44 			enable-gpios = <&gpio 40 0>;