Lines Matching +full:zero +full:- +full:initialised
1 # SPDX-License-Identifier: GPL-2.0
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Liam Girdwood <lgirdwood@gmail.com>
11 - Mark Brown <broonie@kernel.org>
14 regulator-name:
18 regulator-min-microvolt:
21 regulator-max-microvolt:
24 regulator-microvolt-offset:
27 regulator-min-microamp:
30 regulator-max-microamp:
33 regulator-input-current-limit-microamp:
36 regulator-always-on:
40 regulator-boot-on:
49 regulator-allow-bypass:
53 regulator-allow-set-load:
57 regulator-ramp-delay:
59 disabling ramp rate, it should be explicitly initialised to zero (regulator-ramp-delay
63 regulator-enable-ramp-delay:
72 regulator-settling-time-us:
77 regulator-settling-time-up-us:
83 regulator-settling-time-down-us:
89 regulator-soft-start:
93 regulator-initial-mode:
99 regulator-allowed-modes:
101 for the regulator at run-time. Elements may be specified in any order.
105 $ref: "/schemas/types.yaml#/definitions/uint32-array"
107 regulator-system-load:
112 regulator-pull-down:
116 regulator-over-current-protection:
120 regulator-active-discharge:
129 regulator-coupled-with:
131 is 2-way - all coupled regulators should be linked with each other.
133 $ref: "/schemas/types.yaml#/definitions/phandle-array"
135 regulator-coupled-max-spread:
138 couple specified by the regulator-coupled-with property.
141 regulator-max-step-microvolt:
146 ".*-supply$":
149 regulator-state-(standby|mem|disk):
152 sub-nodes for regulator state in Standby, Suspend-to-RAM, and
153 Suspend-to-DISK modes. Equivalent with standby, mem, and disk Linux
157 regulator-on-in-suspend:
161 regulator-off-in-suspend:
165 regulator-suspend-min-microvolt:
168 regulator-suspend-max-microvolt:
171 regulator-suspend-microvolt:
177 regulator-changeable-in-suspend:
182 regulator-mode:
194 - |
196 regulator-min-microvolt = <1000000>;
197 regulator-max-microvolt = <2500000>;
198 regulator-always-on;
199 vin-supply = <&vin>;
201 regulator-state-mem {
202 regulator-on-in-suspend;