Lines Matching full:description

15     description: A string used as a descriptive name for regulator outputs
19     description: smallest voltage consumers may set
22     description: largest voltage consumers may set
25     description: Offset applied to voltages to compensate for voltage drops
28     description: smallest current consumers may set
31     description: largest current consumers may set
34     description: maximum input current regulator allows
37     description: boolean, regulator should never be disabled
41     description: bootloader/firmware enabled regulator.
50     description: allow the regulator to go into bypass mode
54     description: allow the regulator performance level to be configured
58     description: ramp delay for regulator(in uV/us) For hardware which supports
64     description: The time taken, in microseconds, for the supply rail to
73     description: Settling time, in microseconds, for voltage change if regulator
78     description: Settling time, in microseconds, for voltage increase if
84     description: Settling time, in microseconds, for voltage decrease if
90     description: Enable soft start so that voltage ramps slowly
94     description: initial operating mode. The set of possible operating modes
100     description: list of operating modes that software is allowed to configure
108     description: Load in uA present on regulator that is not captured by
113     description: Enable pull down resistor when the regulator is disabled.
117     description: Enable over current protection.
121     description: |
130     description: Regulators with which the regulator is coupled. The linkage
136     description: Array of maximum spread between voltages of coupled regulators
142     description: Maximum difference between current and target voltages
147     description: Input supply phandle(s) for this node
151     description:
158         description: regulator should be on in suspend state.
162         description: regulator should be off in suspend state.
166         description: minimum voltage may be set in suspend state.
169         description: maximum voltage may be set in suspend state.
172         description: the default voltage which regulator would be set in
178         description: whether the default voltage and the regulator on/off
183         description: operating mode in the given suspend state. The set