Lines Matching +full:active +full:- +full:low
9 When the power-off handler is called, the gpio is configured as an
10 output, and drive active, so triggering a level triggered power off
11 condition. This will also cause an inactive->active edge condition, so
13 the GPIO is set to inactive, thus causing an active->inactive edge,
15 delay the GPIO is driver active again. If the power is still on and
19 - compatible : should be "gpio-poweroff".
20 - gpios : The GPIO to set high/low, see "gpios property" in
22 low to power down the board set it to "Active Low", otherwise set
23 gpio to "Active High".
26 - input : Initially configure the GPIO line as an input. Only reconfigure
27 it to an output when the power-off handler is called. If this optional
30 - active-delay-ms: Delay (default 100) to wait after driving gpio active
31 - inactive-delay-ms: Delay (default 100) to wait after driving gpio inactive
32 - timeout-ms: Time to wait before asserting a WARN_ON(1). If nothing is
37 gpio-poweroff {
38 compatible = "gpio-poweroff";
40 timeout-ms = <3000>;