Lines Matching full:definition

9 	Definition: must be one of:
39 	Definition: Register base of the GPIO block and length.
44 	Definition: Must contain an array of encoded interrupt specifiers for
50 	Definition: Mark the device node as a GPIO controller
55 	Definition: Must be 2;
90 	Definition: List of gpio pins affected by the properties specified in
117 	Definition: Specify the alternative function to be configured for the
134 	Definition: The specified pins should be configured as no pull.
139 	Definition: The specified pins should be configured as pull down.
144 	Definition: The specified pins should be configured as pull up.
149 	Definition: Specifies the strength to use for pull up, if selected.
162 	Definition: The specified pins will put in high-Z mode and disabled.
167 	Definition: The specified pins are put in input mode.
172 	Definition: The specified pins are configured in output mode, driven
178 	Definition: The specified pins are configured in output mode, driven
184 	Definition: Selects the power source for the specified pins. Valid
191 	Definition: Selects the drive strength for the specified pins. Value
202 	Definition: The specified pins are configured in push-pull mode.
207 	Definition: The specified pins are configured in open-drain mode.
212 	Definition: The specified pins are configured in open-source mode.
217 	Definition: The specified pins are configured in analog-pass-through mode.
222 	Definition: Selects ATEST rail to route to GPIO when it's configured
229 	Definition: Selects DTEST rail to route to GPIO when it's configured