Lines Matching +full:gpio +full:- +full:reserved +full:- +full:ranges
6 - compatible:
9 Definition: must be "qcom,apq8084-pinctrl"
11 - reg:
13 Value type: <prop-encoded-array>
16 - interrupts:
18 Value type: <prop-encoded-array>
21 - interrupt-controller:
26 - #interrupt-cells:
30 in <dt-bindings/interrupt-controller/irq.h>
32 - gpio-controller:
35 Definition: identifies this node as a gpio controller
37 - #gpio-cells:
41 in <dt-bindings/gpio/gpio.h>
43 - gpio-ranges:
45 Definition: see ../gpio/gpio.txt
47 - gpio-reserved-ranges:
49 Definition: see ../gpio/gpio.txt
51 Please refer to ../gpio/gpio.txt and ../interrupt-controller/interrupts.txt for
52 a general description of GPIO and interrupt bindings.
54 Please refer to pinctrl-bindings.txt in this directory for details of the
62 parameters, such as pull-up, drive strength, etc.
77 The following generic properties as defined in pinctrl-bindings.txt are valid
80 - pins:
82 Value type: <string-array>
83 Definition: List of gpio pins affected by the properties specified in
85 gpio0-gpio146,
93 - function:
97 specified pins. Functions are only valid for gpio pins.
113 gp_mn, gp_pdm0, gp_pdm1, gp_pdm2, gp0_clk, gp1_clk, gpio,
122 - bias-disable:
127 - bias-pull-down:
132 - bias-pull-up:
137 - output-high:
144 - output-low:
151 - drive-strength:
160 compatible = "qcom,apq8084-pinctrl";
163 gpio-controller;
164 #gpio-cells = <2>;
165 gpio-ranges = <&tlmm 0 0 147>;
166 interrupt-controller;
167 #interrupt-cells = <2>;
170 uart2: uart2-default {
178 drive-strength = <4>;
179 bias-disable;
184 drive-strength = <2>;
185 bias-pull-up;