Lines Matching +full:flash +full:- +full:gpios
1 Freescale Localbus UPM programmed to work with NAND flash
4 - compatible : "fsl,upm-nand".
5 - reg : should specify localbus chip select and size used for the chip.
6 - fsl,upm-addr-offset : UPM pattern offset for the address latch.
7 - fsl,upm-cmd-offset : UPM pattern offset for the command latch.
10 - fsl,upm-addr-line-cs-offsets : address offsets for multi-chip support.
12 - gpios : may specify optional GPIOs connected to the Ready-Not-Busy pins
13 (R/B#). For multi-chip devices, "n" GPIO definitions are required
17 - fsl,upm-wait-flags : add chip-dependent short delays after running the
20 - chip-delay : chip dependent delay for transferring data from array to
21 read registers (tR). Required if property "gpios" is not used
24 Each flash chip described may optionally contain additional sub-nodes
31 compatible = "fsl,upm-nand";
33 fsl,upm-addr-offset = <16>;
34 fsl,upm-cmd-offset = <8>;
35 gpios = <&qe_pio_e 18 0>;
37 flash {
38 #address-cells = <1>;
39 #size-cells = <1>;
49 #address-cells = <0>;
50 #size-cells = <0>;
51 compatible = "tqc,tqm8548-upm-nand", "fsl,upm-nand";
53 fsl,upm-addr-offset = <0x10>;
54 fsl,upm-cmd-offset = <0x08>;
55 /* Multi-chip NAND device */
56 fsl,upm-addr-line-cs-offsets = <0x0 0x200>;
59 #address-cells = <1>;
60 #size-cells = <1>;