Lines Matching +full:buck2 +full:- +full:in +full:- +full:supply
4 - https://www.dialog-semiconductor.com/products/da9062
5 - https://www.dialog-semiconductor.com/products/da9061
9 Device Supply Names Description
10 ------ ------------ -----------
11 da9062-regulator : : LDOs & BUCKs
12 da9062-rtc : : Real-Time Clock
13 da9062-onkey : : On Key
14 da9062-watchdog : : Watchdog Timer
15 da9062-thermal : : Thermal
16 da9062-gpio : : GPIOs
20 Device Supply Names Description
21 ------ ------------ -----------
22 da9062-regulator : : LDOs & BUCKs
23 da9062-onkey : : On Key
24 da9062-watchdog : : Watchdog Timer
25 da9062-thermal : : Thermal
31 - compatible : Should be
34 - reg : Specifies the I2C slave address (this defaults to 0x58 but it can be
36 - interrupts : IRQ line information.
37 - interrupt-controller
39 See Documentation/devicetree/bindings/interrupt-controller/interrupts.txt for
44 - gpio-controller : Marks the device as a gpio controller.
45 - #gpio-cells : Should be two. The first cell is the pin number and the
51 Sub-nodes:
53 - regulators : This node defines the settings for the LDOs and BUCKs.
57 buck2 : BUCK_2
68 buck2 : BUCK_2
76 details of individual regulator device can be found in:
79 regulator-initial-mode may be specified for buck regulators using mode values
80 from include/dt-bindings/regulator/dlg,da9063-regulator.h.
82 - rtc : This node defines settings required for the Real-Time Clock associated
83 with the DA9062. There are currently no entries in this binding, however
84 compatible = "dlg,da9062-rtc" should be added if a node is created.
86 - onkey : See ../input/da9062-onkey.txt
88 - watchdog: See ../watchdog/da9062-watchdog.txt
90 - thermal : See ../thermal/da9062-thermal.txt
97 interrupt-parent = <&gpio6>;
99 interrupt-controller;
102 compatible = "dlg,da9062-rtc";
107 regulator-name = "BUCK1";
108 regulator-min-microvolt = <300000>;
109 regulator-max-microvolt = <1570000>;
110 regulator-min-microamp = <500000>;
111 regulator-max-microamp = <2000000>;
112 regulator-initial-mode = <DA9063_BUCK_MODE_SYNC>;
113 regulator-boot-on;
116 regulator-name = "LDO_1";
117 regulator-min-microvolt = <900000>;
118 regulator-max-microvolt = <3600000>;
119 regulator-boot-on;