Lines Matching +full:sense +full:- +full:freq
4 axp152 (X-Powers)
5 axp202 (X-Powers)
6 axp209 (X-Powers)
7 axp221 (X-Powers)
8 axp223 (X-Powers)
9 axp803 (X-Powers)
10 axp806 (X-Powers)
11 axp809 (X-Powers)
12 axp813 (X-Powers)
20 - compatible: should be one of:
21 * "x-powers,axp152"
22 * "x-powers,axp202"
23 * "x-powers,axp209"
24 * "x-powers,axp221"
25 * "x-powers,axp223"
26 * "x-powers,axp803"
27 * "x-powers,axp806"
28 * "x-powers,axp805", "x-powers,axp806"
29 * "x-powers,axp809"
30 * "x-powers,axp813"
31 - reg: The I2C slave address or RSB hardware address for the AXP chip
32 - interrupts: SoC NMI / GPIO interrupt connected to the PMIC's IRQ pin
33 - interrupt-controller: The PMIC has its own internal IRQs
34 - #interrupt-cells: Should be set to 1
38 - regulator-ramp-delay: sets the ramp up delay in uV/us
41 - regulator-soft-start: enable the output at the lowest possible voltage and
43 AXP20x/LDO3: software-based implementation
46 - x-powers,dcdc-freq: defines the work frequency of DC-DC in KHz
47 AXP152/20X: range: 750-1875, Default: 1.5 MHz
48 AXP22X/8XX: range: 1800-4050, Default: 3 MHz
50 - x-powers,drive-vbus-en: boolean, set this when the N_VBUSEN pin is
57 - x-powers,self-working-mode and
58 x-powers,master-mode: Boolean (axp806 only). Set either of these when the
59 PMIC is wired for self-working mode or master mode.
63 - <input>-supply: a phandle to the regulator supply node. May be omitted if
67 - regulators: A node that houses a sub-node for each regulator. Regulators
74 - x-powers,dcdc-workmode: 1 for PWM mode, 0 for AUTO (PWM/PFM) mode
80 probably makes sense for HiFi audio related
86 --------- ---- ----------- -----
87 DCDC2 : DC-DC buck : vin2-supply
88 DCDC3 : DC-DC buck : vin3-supply
89 LDO1 : LDO : acin-supply : always on
90 LDO2 : LDO : ldo24in-supply : shared supply
91 LDO3 : LDO : ldo3in-supply
92 LDO4 : LDO : ldo24in-supply : shared supply
93 LDO5 : LDO : ldo5in-supply
98 --------- ---- ----------- -----
99 DCDC1 : DC-DC buck : vin1-supply
100 DCDC2 : DC-DC buck : vin2-supply
101 DCDC3 : DC-DC buck : vin3-supply
102 DCDC4 : DC-DC buck : vin4-supply
103 DCDC5 : DC-DC buck : vin5-supply
106 ALDO1 : LDO : aldoin-supply : shared supply
107 ALDO2 : LDO : aldoin-supply : shared supply
108 ALDO3 : LDO : aldoin-supply : shared supply
109 DLDO1 : LDO : dldoin-supply : shared supply
110 DLDO2 : LDO : dldoin-supply : shared supply
111 DLDO3 : LDO : dldoin-supply : shared supply
112 DLDO4 : LDO : dldoin-supply : shared supply
113 ELDO1 : LDO : eldoin-supply : shared supply
114 ELDO2 : LDO : eldoin-supply : shared supply
115 ELDO3 : LDO : eldoin-supply : shared supply
116 LDO_IO0 : LDO : ips-supply : GPIO 0
117 LDO_IO1 : LDO : ips-supply : GPIO 1
118 RTC_LDO : LDO : ips-supply : always on
119 DRIVEVBUS : Enable output : drivevbus-supply : external regulator
124 --------- ---- ----------- -----
125 DCDC1 : DC-DC buck : vin1-supply
126 DCDC2 : DC-DC buck : vin2-supply : poly-phase capable
127 DCDC3 : DC-DC buck : vin3-supply : poly-phase capable
128 DCDC4 : DC-DC buck : vin4-supply
129 DCDC5 : DC-DC buck : vin5-supply : poly-phase capable
130 DCDC6 : DC-DC buck : vin6-supply : poly-phase capable
132 ALDO1 : LDO : aldoin-supply : shared supply
133 ALDO2 : LDO : aldoin-supply : shared supply
134 ALDO3 : LDO : aldoin-supply : shared supply
135 DLDO1 : LDO : dldoin-supply : shared supply
136 DLDO2 : LDO : dldoin-supply : shared supply
137 DLDO3 : LDO : dldoin-supply : shared supply
138 DLDO4 : LDO : dldoin-supply : shared supply
139 ELDO1 : LDO : eldoin-supply : shared supply
140 ELDO2 : LDO : eldoin-supply : shared supply
141 ELDO3 : LDO : eldoin-supply : shared supply
142 FLDO1 : LDO : fldoin-supply : shared supply
143 FLDO2 : LDO : fldoin-supply : shared supply
144 LDO_IO0 : LDO : ips-supply : GPIO 0
145 LDO_IO1 : LDO : ips-supply : GPIO 1
146 RTC_LDO : LDO : ips-supply : always on
147 DRIVEVBUS : Enable output : drivevbus-supply : external regulator
152 --------- ---- ----------- -----
153 DCDCA : DC-DC buck : vina-supply : poly-phase capable
154 DCDCB : DC-DC buck : vinb-supply : poly-phase capable
155 DCDCC : DC-DC buck : vinc-supply : poly-phase capable
156 DCDCD : DC-DC buck : vind-supply : poly-phase capable
157 DCDCE : DC-DC buck : vine-supply : poly-phase capable
158 ALDO1 : LDO : aldoin-supply : shared supply
159 ALDO2 : LDO : aldoin-supply : shared supply
160 ALDO3 : LDO : aldoin-supply : shared supply
161 BLDO1 : LDO : bldoin-supply : shared supply
162 BLDO2 : LDO : bldoin-supply : shared supply
163 BLDO3 : LDO : bldoin-supply : shared supply
164 BLDO4 : LDO : bldoin-supply : shared supply
165 CLDO1 : LDO : cldoin-supply : shared supply
166 CLDO2 : LDO : cldoin-supply : shared supply
167 CLDO3 : LDO : cldoin-supply : shared supply
168 SW : On/Off Switch : swin-supply
170 Additionally, the AXP806 DC-DC regulators support poly-phase arrangements
176 --------- ---- ----------- -----
177 DCDC1 : DC-DC buck : vin1-supply
178 DCDC2 : DC-DC buck : vin2-supply
179 DCDC3 : DC-DC buck : vin3-supply
180 DCDC4 : DC-DC buck : vin4-supply
181 DCDC5 : DC-DC buck : vin5-supply
184 ALDO1 : LDO : aldoin-supply : shared supply
185 ALDO2 : LDO : aldoin-supply : shared supply
186 ALDO3 : LDO : aldoin-supply : shared supply
187 DLDO1 : LDO : dldoin-supply : shared supply
188 DLDO2 : LDO : dldoin-supply : shared supply
189 ELDO1 : LDO : eldoin-supply : shared supply
190 ELDO2 : LDO : eldoin-supply : shared supply
191 ELDO3 : LDO : eldoin-supply : shared supply
192 LDO_IO0 : LDO : ips-supply : GPIO 0
193 LDO_IO1 : LDO : ips-supply : GPIO 1
194 RTC_LDO : LDO : ips-supply : always on
195 SW : On/Off Switch : swin-supply
200 --------- ---- ----------- -----
201 DCDC1 : DC-DC buck : vin1-supply
202 DCDC2 : DC-DC buck : vin2-supply : poly-phase capable
203 DCDC3 : DC-DC buck : vin3-supply : poly-phase capable
204 DCDC4 : DC-DC buck : vin4-supply
205 DCDC5 : DC-DC buck : vin5-supply : poly-phase capable
206 DCDC6 : DC-DC buck : vin6-supply : poly-phase capable
207 DCDC7 : DC-DC buck : vin7-supply
208 ALDO1 : LDO : aldoin-supply : shared supply
209 ALDO2 : LDO : aldoin-supply : shared supply
210 ALDO3 : LDO : aldoin-supply : shared supply
211 DLDO1 : LDO : dldoin-supply : shared supply
212 DLDO2 : LDO : dldoin-supply : shared supply
213 DLDO3 : LDO : dldoin-supply : shared supply
214 DLDO4 : LDO : dldoin-supply : shared supply
215 ELDO1 : LDO : eldoin-supply : shared supply
216 ELDO2 : LDO : eldoin-supply : shared supply
217 ELDO3 : LDO : eldoin-supply : shared supply
218 FLDO1 : LDO : fldoin-supply : shared supply
219 FLDO2 : LDO : fldoin-supply : shared supply
220 FLDO3 : LDO : fldoin-supply : shared supply
221 LDO_IO0 : LDO : ips-supply : GPIO 0
222 LDO_IO1 : LDO : ips-supply : GPIO 1
223 RTC_LDO : LDO : ips-supply : always on
224 SW : On/Off Switch : swin-supply
225 DRIVEVBUS : Enable output : drivevbus-supply : external regulator
230 compatible = "x-powers,axp209";
232 interrupt-parent = <&nmi_intc>;
234 interrupt-controller;
235 #interrupt-cells = <1>;
238 x-powers,dcdc-freq = <1500>;
241 regulator-always-on;
242 regulator-min-microvolt = <1000000>;
243 regulator-max-microvolt = <1450000>;
244 regulator-name = "vdd-cpu";
248 regulator-always-on;
249 regulator-min-microvolt = <1000000>;
250 regulator-max-microvolt = <1400000>;
251 regulator-name = "vdd-int-dll";
255 regulator-always-on;
256 regulator-min-microvolt = <1200000>;
257 regulator-max-microvolt = <1400000>;
258 regulator-name = "vdd-rtc";
262 regulator-always-on;
263 regulator-min-microvolt = <2700000>;
264 regulator-max-microvolt = <3300000>;
265 regulator-name = "avcc";