Lines Matching +full:touchscreen +full:- +full:fuzz +full:- +full:y

1 * Cypress cyttsp touchscreen controller
4  - compatible		: must be "cypress,cyttsp-i2c" or "cypress,cyttsp-spi"
5  - reg			: Device I2C address or SPI chip select number
6  - spi-max-frequency	: Maximum SPI clocking speed of the device (for cyttsp-spi)
7  - interrupts		: (gpio) interrupt to which the chip is connected
9  - bootloader-key	: the 8-byte bootloader key that is required to switch
16  - reset-gpios		: the reset gpio the chip is connected to
18  - touchscreen-size-x	: horizontal resolution of touchscreen (in pixels)
19  - touchscreen-size-y	: vertical resolution of touchscreen (in pixels)
20  - touchscreen-fuzz-x	: horizontal noise value of the absolute input device
22  - touchscreen-fuzz-y	: vertical noise value of the absolute input device
24  - active-distance	: the distance in pixels beyond which a touch must move
26 			  Valid values: 0-15.
27  - active-interval-ms	: the minimum period in ms between consecutive
29 			  Valid values: 0-255.
30  - lowpower-interval-ms	: the minimum period in ms between consecutive
31 			  scanning/processing cycles when the chip is in low-power mode.
32 			  Valid values: 0-2550
33  - touch-timeout-ms	: minimum time in ms spent in the active power state while no
34 			  touches are detected before entering low-power mode.
35 			  Valid values: 0-2550
36  - use-handshake	: enable register-based handshake (boolean). This should
42 [0]: Documentation/devicetree/bindings/interrupt-controller/interrupts.txt
49 			compatible = "cypress,cyttsp-i2c";
51 			interrupt-parent = <&gpio0>;
53 			reset-gpios = <&gpio3 4 GPIO_ACTIVE_LOW>;
55 			touchscreen-size-x = <800>;
56 			touchscreen-size-y = <480>;
57 			touchscreen-fuzz-x = <4>;
58 			touchscreen-fuzz-y = <7>;
60 			bootloader-key = /bits/ 8 <0x01 0x02 0x03 0x04 0x05 0x06 0x07 0x08>;
61 			active-distance = <8>;
62 			active-interval-ms = <0>;
63 			lowpower-interval-ms = <200>;
64 			touch-timeout-ms = <100>;
73 			compatible = "cypress,cyttsp-spi";
74 			spi-max-frequency = <6000000>;
76 			interrupt-parent = <&gpio0>;
78 			reset-gpios = <&gpio3 4 GPIO_ACTIVE_LOW>;
80 			touchscreen-size-x = <800>;
81 			touchscreen-size-y = <480>;
82 			touchscreen-fuzz-x = <4>;
83 			touchscreen-fuzz-y = <7>;
85 			bootloader-key = /bits/ 8 <0x01 0x02 0x03 0x04 0x05 0x06 0x07 0x08>;
86 			active-distance = <8>;
87 			active-interval-ms = <0>;
88 			lowpower-interval-ms = <200>;
89 			touch-timeout-ms = <100>;