Lines Matching full:i3c
1 Generic device tree bindings for I3C busses
4 This document describes generic bindings that should be used to describe I3C
12 - compatible - name of the I3C master controller driving the I3C bus
16 The node describing an I3C bus should be named i3c-master.
21 These properties may not be supported by all I3C master drivers. Each I3C
24 - i3c-scl-hz: frequency of the SCL signal used for I3C transfers.
48 + third cell: shall encode the I3C LVR (Legacy Virtual Register)
68 I3C devices
71 All I3C devices are supposed to support DAA (Dynamic Address Assignment), and
72 are thus discoverable. So, by default, I3C devices do not have to be described
76 means we have to describe I3C devices.
78 Another use case for describing an I3C device in the device tree is when this
79 I3C device has a static I2C address and we want to assign it a specific I3C
83 The I3C device should be names <device-type>@<static-i2c-address>,<i3c-pid>,
98 following the PID definition provided by the I3C
104 property is only valid if the I3C device has a static
110 i3c-master@d040000 {
111 compatible = "cdns,i3c-master";
126 /* I3C device with a static I2C address. */
133 * I3C device without a static I2C address but requiring