Lines Matching refs:synthesizer

31 user is using a hardware synthesizer, then Speakup will be able to
43 specific synthesizer by default, then all you need to do to use Speakup
45 assumes of course  that your synthesizer is a supported hardware
46 synthesizer, and that it is either installed in or connected to your
50 kernel with no default synthesizer.  It is even possible that your
53 your synthesizer is supported but not available, complain to the person
59 synthesizer set, or you would like to use a different synthesizer than
66 DoubleTalk LT at boot up.  You may replace the ltlk synthesizer keyword
67 with the keyword for whatever synthesizer you wish to use.  The
108 proper bootup parameter for your synthesizer, Speakup will begin
421 driver for the software synthesizer.  If you use the LiteTalk, your
422 synthesizer-specific settings would be found in /speakup/ltlk.  In other words,
505 number of the driver for the current synthesizer.
512 # Replace KWD with the keyword for your synthesizer, E.G., ltlk for LiteTalk.
515 The number five which comes back is the level at which the synthesizer
528 It is possible to change to a different synthesizer while speakup is
530 in order to use a different synthesizer.  You can simply echo the
531 synthesizer keyword to the /speakup/synth sys entry.
533 sys entry, to disable speech while one synthesizer is disconnected and
535 new synthesizer into the synth sys entry in order to start speech
536 with the newly connected synthesizer.  See the list of synthesizer
554 the synthesizer driver you wish to use.  The driver modules are all
556 synthesizer you want.  So, in order to load the driver for the DecTalk
588 of by simply echoing the synthesizer keyword into the
603 Using a software synthesizer requires that some other software be
615 software synthesizer, you must have created the /dev/softsynth device.
623 synthesizer.  To create /dev/synth, change to the /dev directory, and
632 Espeakup is a connector between Speakup and the eSpeak software synthesizer.
687 chosen software synthesizer, you still need one more piece of software
691 your software synthesizer.
693 Now you can begin using your software synthesizer.  In order to do so,
737 will accept a number from 0 through 7 for the DecTalk PC synthesizer,
973 and they could not be changed.  If you used a non-English synthesizer,
1157 Talkwith allows you to switch synthesizers on the fly.  It takes a synthesizer
1161 software synthesizer, you must also indicate which daemon you wish to
1175 synthesizer is activated.  You can use speakupconf to load your settings